Heath Zenith HB-4190 Series manual Operation, Features, Requirements, Mode Switching Summary

Motion Sensing Diecast Lantern

HB-4190 Series

Features

TEST

Set the ON-TIME switch
on the bottom of the cover
plate to TEST.	TEST 1	5 10	MIN
AUTO
Set ON-TIME switch to 1,
5 or 10 minutes.
	TEST 1	5 10	MIN

MANUAL MODE

•Light comes on when motion is detected.

•Automatically turns light off.

•Dusk Accent lighting.

•Photocell keeps the light off during daylight hours.

This package includes:

•	Lantern
• Easy to use universal mounting bracket
	(X-Bar)
• Mounting hardware
•	Wire nuts
•	Light Bulb(s)

Manual mode only works at night because daylight re- turns the sensor to AUTO.

Flip the light switch off for one second then back on to toggle between AUTO and

MANUAL MODE.

Manual mode works only with the ON-TIME switch in the 1, 5, or 10 position.

1Second OFF then...

... back on.

Requirements

•The light control requires 120 volts AC.

•If you want to use Manual Mode, the control must be wired through a switch.

•Some codes require installation by a qualified electrician.

OPERATION

Mode:	On-Time	Works: Day	Night
Test	5 Seconds	x	x
Auto	1, 5, or 10 Min		x
Manual	To Dawn*		x
Accent	3,6 Hr. to Dawn		x

* resets to Auto Mode at dawn.

Note: When first turned on wait about 1 1/2 minutes for the circuitry to calibrate.

Mode Switching Summary

	TEST	ON-TIME Switch at 1,
			5, or 10 minutes
	AUTO		Flip light switch
			off for one second
MANUAL MODE
			then back on*

*If you get confused while switching modes, turn the power off for one minute, then back on. After the calibration time the control will be in the AUTO mode.

DualBrite® Dimmer Control

Light comes on half bright for selected time after dusk (3 hr., 6 hr., until dawn). If motion is sensed, the light turns on full bright for the ON-TIME (1, 5, or 10 minutes) then returns to dim mode.

© 2008 595-5770-05