Wire the Light Control
WARNING: Turn power off at circuit breaker or fuse.
❒Remove the existing light fixture.
❒Install mounting strap to junction box using screws appropriate for your junction box.
❒The plastic hanger can be used to hold the fixture while wiring. The small end of the plastic hanger can be threaded through the hole in the center of the cover plate. The small end then goes into one of the slots on the mounting strap.
❒Thread all fixture wires through the large holes in the gasket as shown.
❒Connect the junction box wires to the light fixture wires as shown. Twist together and secure with wire connectors.
Mount the Light Control
❒Align the light control cover plate and cover plate gasket. Secure with the mounting bolt.
❒Align the three slots in the decorative shell with the lamp holder pins. Push the shell in and then twist clockwise to lock. Repeat for other shell.
Shell Slot
❒Push the rubber plug firmly into place.
❒If a wet location junction box was not used, caulk the wall plate mounting surface with silicone weather sealant.
Black to Black
White to White
Gasket
Rubber Plug
Mounting
Bolt
To avoid water damage and electrical shock, keep lamp holders 30° below horizontal.
Connect any fixture ground wire(s) to the junction box ground wire.
Lock Nut Lens 
Keep lamps at least 1" (2.5 cm) from both sensors.Do not allow the lamps to block either lens.
❒Adjust the lamp holders by loosening the lock nuts but do not rotate the lamp holders more than 180° from the factory setting. When screwing in the flood lamps, do not overtighten.
3 |
