Heath Zenith PF-4300-BK Install Fixture Base to, Junction Box, Testing, Sensitivity, DualBrite

It is also possible to wire two motion sensing lights so that either fixture will turn on both lights at the same time(dualmastersystem).Itisrecommendedthatonly people with electrical wiring experience attempt this configuration.Pleasecallourcustomerservicenumber (1-800-858-8501 - English Speaking Only) before attempting this wiring. If the dual controlled wiring is not done correctly, it can destroy both motion sensing fixtures and void your warranty.

Install Fixture Base to

DUAL	BRITE
		DUDASKWN
3	6	TO
OFF			N
		10 MI
1	5ME
TESTON-TI

Sensor

Lens

DualBrite®

DUSK

OFF 3HR 6HR TO DAWN

TEST 1 5 10 MIN

ON-TIME

Junction Box

1.Push wires into the junction box.

2.Slide light fixture base onto fixture screws and tighten decorative nuts snugly against the base.

3.Install four candelabra base light bulbs (25 Watts maximum each).

4.Refer to TESTING section before installing cover.

5.After switches are set and testing is complete, use the 2 decorative nuts to install the cover.

Junction Box

25 Watt Candelabra	Fixture Screw
Base Bulb

DUAL	BRITE
		DUDASKWN
3 6		TO
OFF			N
		10 MI
1	5ME
TESTON-TI

Decorative Nut

Testing

1.Turn on the circuit breaker and light switch.

Note: Sensor has a 1 1/2 minute warm up period before it will detect motion. When first turned on wait 1 1/2 minutes.

Note: Meets the ENERGY STAR® guidelines when DualBrite® function is off.

2. Set the ON-TIME switch to the TEST position and the DualBrite® switch to the OFF position.

598-1169-05

3.Walk through the coverage area noting where you are when the lights turn on. In TEST mode, light will stay on for only 5 seconds then turn off.

4.AdjusttheSENSITIVITYtoincreaseordecrease the range as needed. Too much sensitivity may cause false triggering due to heat sources in the coverage area (see Adjustment of Coverage Area or Troubleshooting section).

		SENSITIVITY
SEN+	SITIVITY–	+	–

5.Set the amount of ON-TIME you want the light to stay on after motion is detected (1, 5, or 10 minutes).

6.Set the amount of time you want the light to stay on in the Accent mode (Off, 3 hours, 6 hours, or dusk-to-dawn).

	360°
8 ft. (2.4 m)
30 Feet (9.1 m)
in all Directions
Maximum Range	C o v e r a g e
Angle*	(Top View)

* Without lens shield installed.