Wire the Light Control
WARNING: Turn power off at circuit breaker or fuse.
❒Remove the existing light fixture.
❒Install mounting strap to junction box using screws appropriate for your junction box.
❒The plastic hanger can be used to hold the fixture while wiring. The small end of the plastic hanger can be threaded through the hole in the center of the cover plate. The small end then goes into one of the slots on the mounting strap.
❒Route all fixture wires through the large holes in the gasket as shown.
❒Connect the junction box wires to the light fixture wires as shown.Twist together and secure with wire connectors.
Mount the Light Control
❒Place the mounting bolt through the front of the junction box cover. Push the small gasket hole over the mounting screw.
❒Make sure the wire connectors and wires are inside the junction box. Align the mounting screw with the center hole in the mounting strap.Secure the fixture to the mounting strap.
❒Push the rubber plug firmly into place.
❒Ifawetlocationjunctionboxwasnotused,caulkthewall plate mounting surface with silicone weather sealant.
Lamp Shade
Set Screw Lock Nuts
Mounting
Strap
White to
White
Black to
Black Rubber Plug
Mounting
Bolt
Gasket
Keep bulbs at least 2" (51 mm) from the sen-
sor and 2" (51 mm) from combustibles.
❒Adjust the bulb holders by loosening the lock nuts, but do not rotate the bulb holders more than 180° from the factory setting.
❒Adjust lamp shades by loosening the set screws several turns, turn shades counterclockwise and remove.Reinstall the shades in the desired position and tighten set screws.
Connect any fixture ground wire(s) and the cover plate ground screw to the junction box ground wire.
