Adding Decorative Tail
The detector is less sensitive to motion directly towards it.
2. Screw in exten- sion bar.
1.Remove decorative nut from bottom of
fixture.
3.Add tail piece and
trim.
4.Screw decorative
nut back on.
MotionMotion
Sensor |
|
Least Sensitive | Most Sensitive |
❒ Walk through the coverage area noting |
where you are when the lights turn on. |
TESTING
❒Turn on the circuit breaker and light switch. There is a one minute
❒Switch the
TEST 1 5 10 MIN | OFF 3 6 | DUSK TO |
| HOUR | DAWN |
Avoid aiming the control at:
• Pools of water or objects that change temperature rapidly, such as heating vents and air conditioners. These heat sources could cause false triggering.
• Areas where pets or traffic may trigger the control.
• Nearby large,
6 ft. |
Maximum | 30 ft. |
Maximum | |
Range | Coverage Angle |
Rotate the sensor head (maximum 0f |
45°left or right) to change the coverage |
area.45°
|
|
| 240° |
| 90° |
|
|
| Maximum Sensor |
| 45° |
|
|
| |
| Rotatation | Maximum Aiming | |
❒ |
| Range | |
Set the amount of TIME you want the | |||
| light to stay on after motion is detected. | ||
| TEST 1 5 10 MIN | OFF 3 6 | DUSK TO |
| HOUR | DAWN | |
|
| ||
❒Set the amount of time after dusk you want the lights on accent level.
SPECIFICATIONS
Range . . . . . . . . . . . Up to 30 feet (varies during daylight hours).
Sensing Angle . . . . . Up to 150°, 240° aimable Electrical Load . . . . . (3) 60 W. candelabra,
400W (3.3 A.) total
Power Requirements 120 VAC, 60 Hz Operating Modes . . . TEST, AUTO and
MANUAL OVERRIDE
Time Delay . . . . . . . 1 , 5, 10 minutes Accent timer . . . . . . Off, 3, 6 Hrs, to dawn Sensitivity . . . . . . . . Adjustable
The Heath Company reserves the right to discontinue products and to change specifications at any time without incurring any obligation to incorporate new features in products previously sold.
