TROUBLESHOOTING GUIDE
If you experience a problem, follow this guide. If the problem persists, call the assistance at
Lo sentimos, pero no podemos contestar preguntas en español por teléfono.
SYMPTOM | POSSIBLE CAUSE | |
|
|
|
Light will not | 1. | Light switch is turned off. |
come on. | 2. | Bulb is loose or burned out. |
| 3. | Fuse is blown or circuit |
|
| breaker is turned off. |
| 4. | Daylight |
|
| (recheck after dark). |
| 5. | Incorrect circuit wiring, if |
|
| this is a new installation. |
| 6. | |
|
| desired area. |
|
|
|
Light comes | 1. | Light Control may be in- |
on in day- |
| stalled in a relatively dark |
light. |
| location. |
| 2. Light Control is in Test. (Set | |
|
| control switch to an ON- |
|
|
|
Light comes |
| TIME p sition.) |
1. Light Control may be sens- | ||
on for no |
| ing small animals or automo- |
apparent |
| bile traffic |
reason. | 2. | Sensitivity is set too high. |
|
| (Reduce sensitivity.) |
|
|
|
SYMPTOM | POSSIBLE CAUSE | |
|
| |
Light stays on | 1. The sensor is pointed at | |
continuously. | nearby objects that cause | |
| heat to trigger the sensor. | |
| (Aim the sensor away from | |
| nearby objects.) | |
| 2. The sensor is pointed | |
| toward a heat source like | |
| an air vent, dryer vent, or | |
| ||
| reflective surface. | |
| sensor.) | |
|
| |
Light flashes | 1. Heat being reflected from | |
other objects may be | ||
on and off. | ||
affecting the sensor. (Re- | ||
| ||
| aim sensor.) | |
| 2. Light Control is in the Test | |
| mode and warming up. | |
| (Flashing is normal under | |
| these conditions). | |
|
|
YOUR HEATH ZENITH FIVE YEAR LIMITED WARRANTY
This is a “Limited Warranty” as defined in the U.S. Consumer Product Warranty and Federal Trade Commission Improvement Act. This warranty gives you specific legal rights, and you may also have other rights which vary from state to state.
For a period of five years from the date of purchase, any malfunction caused by factory defective parts or workmanship will be corrected at no charge to you. Light bulbs are not covered. To obtain a refund or a replacement, return the product to the place of purchase.
Not Covered — Repair service, adjustment and calibration due to misuse, abuse or negligence, light bulbs and other expendable items are not covered by this warranty. Unauthorized service or modification of the product or of any furnished component will void this warranty in its entirety. This warranty does not include reimbursement for inconvenience, installation,
This warranty covers only Heath Zenith assembled products and is not extended to other equipment and components that a customer uses in conjunction with our products.
SUCH REPAIR OR REPLACEMENT SHALL BE THE SOLE REMEDY OF THE CUSTOMER AND THERE SHALL BE NO LIABILITY ON THE PART OF HEATH FOR ANY SPECIAL, INDIRECT, INCIDENTAL, OR CONSEQUENTIAL DAMAGES, INCLUDING BUT NOT LIMITED TO ANY LOSS OF BUSINESS OR PROFITS, WHETHER OR NOT FORESEEABLE. Some states do not allow the exclusion or limitation of incidental or consequential damages, so the above limitation or exclusion may not apply to you.
