INSTALLATION
For easy installation, select an existing light operated by a wall switch for replacement.
For best performance, mount the fixture about 8 ft. (2.4 m) above the ground.
CAUTION: To Avoid Fire Or Burn Hazards:
•Allow fixture to cool before touching. The bulb and the fixture operate at high temperatures.
•Keep fixture at least 1" (2.5 cm) from combustible ma- terials. Do not aim at objects closer than 3 ft. (1 m).
•Use only T3, 150W (max.) tungsten halogen 120 VAC lamps.
For under eave installation, the sensor head must be rotated as shown in the next two steps for proper operation and to avoid the risk of electrical shock.
For eave mount only:
❒Rotate the sensor head towards the clamp screw joint.
Control Switch
Joint Clamp 
❒Then rotate the sensor head clockwise 180° so the controls face down.
If the sensor pops out of the ball joint, loosen the clamp screw and push the sensor back into the ball joint. Tighten the clamp screw when done.
Bulb Installation
NOTE: When
❒Open glass covers.To remove the old bulb push the bulb towards the right (with fixture as shown) until the left side of the bulb is clear of the left socket.
❒To install a bulb, push the bulb into the right socket so the bulb fits completely into the left socket.
❒Check that the bulb is seated properly.
❒Close the glass covers.
Wire the Light Control
❒Turn power off at the fuse or circuit breaker.
❒Remove the existing light fixture.
❒Install mounting strap to junction box using screws appropriate for your junction box.
❒The plastic hanger can be used to hold the fixture while wiring. The small end of the plastic hanger can be threaded through the hole in the center of the cover plate. The small end then goes into one of the slots on the mounting strap.
❒Thread all fixture wires through the large holes in the gasket as shown.
❒Connect the junction box wires to the light fixture wires as shown.Twist together and secure with wire connectors.
Black to Black 
White to White
Gasket
Rubber
Plug
Mounting Bolt
Connect any fixture ground wire(s) and the cover plate ground screw to the junction box ground wire.
Mount the Light Control
❒Place the mounting bolt through the front of the junction box cover.
❒Make sure the wire connectors and wires are inside the junction box. Align the mounting screw with the center hole in the mounting strap.Secure the fixture to the mounting strap.
❒Push the rubber plug firmly into place.
❒If not installed on a weatherproof box, caulk the wall plate and mounting surface with silicone.
Push the Rubber Plug over the mounting screw.
Keep lamps at least 1" (2.5 cm) |
from the sensor. |
❒Adjust the lamp holders by loosening the lock nuts but do not rotate the lamp holders more than 180° from the factory setting.
