TEST AND ADJUSTMENT
❒Turn on the circuit breaker and light switch.NOTE: Sensor has about 1 1/2 minutes warm up period before it will detect motion. When first turned on, wait about 1 1/2 minutes.
❒Turn the SENSITIVITY (SENS) control to the mid position and the
| SENS | |||||||
| ||||||||
|
|
|
| |||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
10 5 1 TEST |
|
|
|
|
| MIN MAX |
|
|
|
|
| ||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Bottom of Sensor
❒ Loosen the clamp screw in the sensor ball joint and gently rotate the sensor.
❒ Walk through the coverage area noting where you are when the lights turn on. Move the sensor head up, down, or sideways to change the cover- age area. Keep the sensor at least 1" (2.4 cm) away from the lamps.
❒ Adjust the SENSITIVITY as needed. Too much sensitivity may increase false triggering
❒Secure the sensor head’saim by tightening the clamp screw. Do not overtighten the
screw.
❒ Set the amount of TIME you
want the lights to stay on after motion is detected (1, 5, or 10 minutes).
•Objects that change temperature rapidly, such as heating vents and air conditioners. These heat sources could cause false triggering.
•Areas where pets or traffic may trigger the control.
•Nearby large,
110°
8ft.
(2.4 m)
60 ft.
(18.3 m)
Maximum Range | Maximum |
| Coverage Angle |
The detector is less sensitive to motion directly towards it and more sensitive to across motion.
SPECIFICATIONS
Range | Up to 60 ft.(18.3 m) [varies with |
| surrounding temperature]. |
Sensing Angle. . . . | Up to 110° |
Electrical Load. . . . | 300 watt Incandescent [150 |
| Max each lamp holder]. |
Power Requirements. . | 120 VAC, 60 Hz |
Operating Modes. . . | TEST, AUTO and MANUAL |
| MODE |
Time Delay | 1, 5, 10 minutes |
Replacement lamp. . . | T3 150W halogen maximum |
| 120 VAC |
HeathCo LLC reserves the right to discontinue prod- ucts and to change specifications at any time without incurring any obligation to incorporate new features in products previously sold.
MotionMotion
| Sensor |
Least Sensitive | Most Sensitive |
