Heath Zenith manual Motion Sensor Entryway Light, Operation, Models SL-5610/15, On-Time, Test

Motion Sensor

Entryway Light

Models SL-5610/15

The Heath®/Zenith Motion Sensor Entryway Light turns on up to 60 watts of incandescent light when motion is detected and then, after a selectable time period, automatically turns the light off. The built-in photocell keeps the light off during daylight hours.

This package includes:

OPERATION

Mode:	On-Time	Works: Day	Night
Test	5 Seconds	x	x
Auto	1, 5, or 10 Min		x
Manual	Until Dawn*		x

* resets to Auto Mode at dawn.

Note: When first turned on wait about 1 1/2 minutes for the circuitry to calibrate.

TEST

Put the ON-TIME switch on the bottom ON-TIMEof the sensor in the TEST position.

10 5 1 TEST

AUTO

Put the ON-TIME switch in the 1, 5,	ON-TIME
or 10 minute position.
	10 5 1 TEST
MANUAL MODE

Sensor

2 Screws

globe	or	jar
(SL-5615)		(SL-5610)

2 Wire

Connectors

Manual mode only works at night because daylight returns the sensor to AUTO.

Flip the light switch off for one second then back on to toggle between AUTO and MANUAL MODE.

Manual mode works only with the ON-TIME switch in the 1, 5, or 10 position.

1Second OFF then...

Entryway Light

Mounting Nut and Stem	Mounting Strap and
	Grounding Wire

Requirements

•The Entryway Light requires 120-volts AC.

•If you want to use Manual Override, the light must be wired through a switch.

•Some codes require installation by a qualified electrician.

			... back on.
	Mode Switching Summary
	TEST	Move ON-TIME Switch to
			1, 5, or 10 minutes
	AUTO		Flip light switch off
			for one second then
			back on*
MANUAL MODE

*If you get confused while switching modes, turn the power off for one minute, then back on. After the cali- bration time the control will be in the AUTO mode.

© 2007 HeathCo LLC 595-5498-09