INSTALLATION
For best performance, mount the fixture about 7ft (2.1 m) above the ground.
❒Turn the power to the lighting circuit off at the fuse or circuit breaker box.
❒Remove the existing light fixture.
❒Install the mounting strap
into the junction box. Ori- entation of the strap may be different.
❒Strip about 5/8 in. (15 mm)
insulation off of the existing junction box wiring.
❒Connect the white (neutral) junction box wire to the white Entryway Light wire.Twist the wires together and secure with a wire connector.
❒Caulk the back edge of the light and mounting surface with silicone weather sealant.
❒Install a 60 Watt maximum light bulb into the lamp holder. Do not overtighten. Higher wattages will void warranty.
Holding Screw for Globe or Jar
❒Loosen the front holding screw so the globe or jar cover can be installed. Secure by tightening the screw. Do not overtighten.
❒
Connect the green or bare (ground) mounting strap wire to a grounded wire or to a grounded metal box.
❒
Connect the black (hot) junction box wire to the black En- tryway Light wire.
❒
❒
Install the mounting stem into the strap so that it extends out about 3/4 in. (19 mm).
Install the fixture over the mounting stem.
❒ Install and tighten the mounting stem nut.
