Heath Zenith SL-6164 manual Code Settings, Doorbell Button Battery Replacement

Code Settings

Note: Most installations will not require you to change any of the jump- ers on your doorbell.

The doorbell button and chime communicate by using a code that can be changed by removing and/or adding jumpers on both the doorbell button and chime. The code is factory set; however, there are 128 selectable codes that allow you to expand your system and prevent outside interference. Another wireless doorbell system or other wireless products may cause interference and the system may not function properly. Follow the instructions below for setting a new code.

1.Disconnect the power to the doorbell button and chime.

2.Open the cases and locate the jumpers on both the doorbell button and chime (See illustration).

3.The doorbell button and chime both have eight different jumper locations. The jumper positions 1 through 7 are used for setting the code.

4.To change the code, add and/or remove jumpers as needed. There are 128 different combinations. It is recommended to only change one jumper at a time and then check to see if system is functioning properly. Note:

Jumpers in positions 1 through 7 must be exactly the same for both the doorbell button and chime for this system to function.

Note: Models that have doorbell buttons for both front and back doors, the back door must use the Ding tune and the front door may use any tune from the Musical Chime Song List (see page 4).

Doorbell Button Battery Replacement

Install an alkaline type A23 12 Volt battery. The positive terminal should be positioned as shown.

ery
12 345678
B
ery	No Jumper
	Necessary
Inside Chime
595-5707-04

1 234 5678

Inside

Doorbell

Button

-3-

*Code Settings 1-7 Must Match Both Doorbell Button and Chime

Add jumper for back door Ding or remove for front door Music Selection (for models with 2 doorbell buttons only)