Hellenbrand 1 SET SALT MONITOR OPTION

Typically a system is set to regenerate at a time of low water usage. An example

of a time with low water usage is when the household is asleep. If there is a demand

for water when the system is regenerating, untreated water will be supplied.

When the system begins to regenerate, the display will change to include

information about the step of the regeneration process and the time remaining for

that step to be completed. The system runs through the steps automatically and

will reset itself to provide treated water when the regeneration has been completed.

Sometimes there is a need to regenerate the system, sooner than when the

system calls for it, usually referred to as manual regeneration. There may be

a period of heavy water usage because of guests or a heavy laundry day.

To initiate a manual regeneration at the preset delayed regeneration

time, press and release “REGEN”. The words “REGEN TODAY” will flash

on the display to indicate that the system will regenerate at the preset

delayed regeneration time. If you pressed the “REGEN” button in error,

pressing the button again will cancel the request.

To initiate a manual regeneration immediately, press and hold the “REGEN”

button for three seconds. The system will begin to regenerate immediately.

The request cannot be cancelled. You must cycle all the way through the cycles to make it stop. PLEASE NOTE: This will reset the meter.

Note: If the salt keeper does not contain salt. Fill with salt and wait at least two hours before regenerating.

Regeneration Step #2

(shows time remaining in regen step is 8:22)

Figure 11

SET SALT MONITOR OPTION

NOTE: This screen will not appear if system is set up as a filter or the 'set low salt

warning' is set to off. See dealer for details

Step 1US - Press the NEXT button until SALT appears in the display. It does not matter if the

SALT display alternates with the LBS REMAINING display.

Step 2US - Press SET CLOCK

Step 3US - Set LBS REMAINING: Use the ▼ or ▲ button to adjust the pounds remaining in

the brine tank.

NOTE: Estimate the pounds of salt in the brine tank and add it to the amount of salt added

to the brine tank. The example at the left would indicate 200 lbs. of salt being added to a

brine tank that has 40 lbs. remaining.

Step 4US - Press SET CLOCK to exit Adding Salt.

RETURN TO

NORMAL MODE

NOTE: The salt used per regeneration setting can be set in increments

of 0.1 pounds, but LBS REMAINING screen will round up or down to the

closet whole number.

Once the salt remaining as gone below the set point the display will

automatically flash Salt Fill.

Figure 10b