Henny Penny HEC-104, HEC-103, HEC-124, HEC-123 manual Special Program, Mode

				Model HEC-103/104/123/124
3-6. SPECIAL PROGRAM	This mode includes the lock/unlock feature, control initialization, and
MODE	testing of the outputs and displays.
	1.	Turn power switch off.
	2.	Press and hold both		while turning on the power switch.
	3.	“SP” shows in display, followed by “P=L” or P=U”.
	4.	Press	to either lock (“P=L”) or unlock (“P=U”) the controls.

Locking the controls will not allow anyone to change the heat values of the shelves until the controls are unlocked.

5.	Press	.
6.	“In” shows in the display. Press and hold		or	to

re-initialize the controls, which sets all heat settings to “OFF”, or to factory set parameters. “In3”, “In2”, “In1” shows in the display, followed by “In-”, “SyS”, indicating the initialization is complete.

7.Press .

8.“OP” shows in the display. Press and release the shelf buttons (1

to 4) to turn off and on the heat outputs for each shelf. Press and

release to turn off and on the base heat outputs. Press to turn off and on all displays and outputs.

9.Press and hold to exit Special Program Mode.

Press and hold at any time to exit the Special Program Mode, or if no buttons are pressed for 1 minute, controls auto- matically exits Special Program Mode.

3-5 503