1.2Explanation of the pictograms and other information

Warning signs

en

General

Warning:

Warning:

warning

electricity

caustic

 

 

substances

Obligation signs

Wear eye

Wear a hard

Wear ear

Wear

protection

hat

protection

protective

 

 

 

gloves

Wear

breathing protection

Symbols

Read the

Return waste

Volts

Direct current

operating

material for

 

 

instructions

recycling.

 

 

before use

 

 

 

Rated speed

Revolutions

Diameter

Saw blade

under no load

per minute

 

 

1 These numbers refer to the corresponding illustra- tions. The illustrations can be found on the fold-out cover pages. Keep these pages open while studying the operating instructions.

In these operating instructions, the designation “the power tool” always refers to the WSC 70A36 or WSC 55A24 cordless circular saw.

Location of identification data on the power tool The type designation can be found on the type iden- tification plate and the serial number on the side of the motor housing. Make a note of this data in your operating instructions and always refer to it when making an enquiry to your Hilti representative or service department.

Type:

Serial no.:

2. Description

2.1 Use of the product as directed

The power tool is a hand-held, cordless circular saw.

The power tool is designed for sawing wood or wood-like materials, plastics, drywall panel (plasterboard), gypsum fiberboard and composite materials with a thickness of up to 55 or 70 mm (depending on model) and for bevel cuts at angles between 0 ° and 50 °.

Working on materials hazardous to the health (e.g. asbestos) is not permissible.

The power tool is designed for professional use and may be operated, serviced and maintained only by trained, authorized personnel. This personnel must be informed of any special hazards that may be encountered. The power tool and its ancillary equipment may present hazards when used incorrectly by untrained personnel or when used not as directed.

The working environment may be as follows: construction site, workshop, renovation, conversion or new construction.

Modification of the power tool is not permissible.

18

Page 7
Image 7
Hilti WSC 70-A36, WSC 55-A24 Description, Explanation of the pictograms and other information, Obligation signs, Symbols