Hitachi 42EDT41 user manual Color System, Video Input, AV2 1st step, AV2 2nd step

OPERATING INSTRUCTIONS (continued)

SETUP MENU

MENU

CH+

Picture

Audio

Timer

Function

Setup

	Setup
		System	System 2
OK		Color System	OK
		Video Input
		Audio Input

Setup

Color System

AV1	Auto
AV2	NTSC-M

CH-

Language

Select

OK Set

	Scart Output			Monitor
	RGB1			DVI-STB
	RGB2			Component
				HDTV
	Select	OK	Set	Return
				CH+
Setup				CH-
	System			System 2
	Color System				OK
	Video Input
	Audio Input
	Scart Output			Monitor
	RGB1			DVI-STB
	RGB2			Component
				HDTV
	Select	OK	Set	Return
				CH+
Setup				CH-
	System			System 2
	Color System				OK
	Video Input
	Audio Input
	Scart Output			Monitor
	RGB1			DVI-STB
	RGB2			Component
				HDTV
	Select	OK Set		Return

AV3	PAL-M
AV4	PAL-N
Select	Return	Exit

Setup

Video Input
AV1	Auto
AV2	Composite/Component
AV3	Auto
AV4	S.Video
Select	Return	Exit

Setup
	Audio Input
	AV1		Stereo
	AV2		L/Mono
	AV3		Stereo
	AV4		L/Mono
	Select	Return		Exit

Selected characters									Setup hint
System			System1				System2		Do not change the original setting.
									(System1 : Europe/Asia, System2 : North America)
Color System
									This should correspond to the color system of the signal from the
									equipment that is connected to AV1 video input terminal.
				Auto		NTSC-M			• Normally, set this to Auto. The system of the input signal will be
AV1									automatically recognized.
				PAL-N			PAL-M		• If the input signal contains much noise or has a low level at Auto and the
									operation is found erratic, set this to match the input signal.
									• When the component signal is received, this would be not available
									(grayed out).
AV2
AV3									(Same to AV1)
AV4
Video Input
									This should correspond to the signal mode of the signal from the
									equipment that is connected to AV1 video input terminal.
AV1	Auto				HDTV			SDTV/DVD	• Normally, set this to Auto. The signal mode of the input signal will be
									automatically recognized.
									• If the input signal contains much noise or has a low level at Auto and the
									operation is found erratic, set this to match the input signal.
AV2 (1st step)	RGB				Composite/Component				This should correspond to the signal mode of the signal from the
									equipment that is connected to AV2 video input terminal.
AV2 (2nd step)	Auto				HDTV			SDTV/DVD	This step should be set only when [Composite/Component] is selected on
									the 1st step. And the procedure is same to AV1.
									• If the signal from the equipment that is connected to AV4 Scart input
AV4		S.Video				Composite			terminal is S.Video or Composite, set this to correspond to that signal.
									• If the signal is RGB, it will be automatically recognized and this setting
									will have no effect.