Hitachi 42EDT41 user manual Operating Instructions Displaying Multi Picture, Pictures Split

(Sub- screen)

RGB2

AV1

OPERATING INSTRUCTIONS (continued)

Displaying MULTI PICTURE

A/B button

2 Pictures (Split)

PinP button

RECALL button

RETURN button

SELECT button

If the PinP button on the remote control is pressed MULTI PICTURE will display.

Activating the P-in-P mode from the RGB input screen

Pressing the PinP button one time will display 2 pictures.

•This mode can be available from RGB1(DVI-PC) and RGB2(RGB) input.

•The speaker icon can be shifted up and down by pressing the A/B button; the audio of the video will be output from the side on which the speaker icon is located.

• The sub-screen position can be selected up and down by pressing SELECT buttons.

•The sub-screen can be selected with the AV1, AV2, AV3, AV4 and TV channel number buttons from the

status that the speaker icon appears on the left side of AV✱ as shown in the diagram to the right.

•Pressing the PinP button again or the RETURN button will cancel the 2 pictures display.

•"Frequency Mode" in the Setup Menu should be set to Movie when sub-screen is the component signal of 1080i/50 or 1080i/60.

AV1: Displays the VIDEO input signal of the sub-screen.

Activating the Split mode from the video input screen

Pressing the PinP button one
time will display 2 pictures.	AV1	AV2

•The speaker icon can be shifted left and right by pressing the A/B button; the audio of the video will be output from the side on which the speaker icon is located.

•The same video input mode cannot be selected for both screens at the same time.

•Pressing the PinP button again or the RETURN button will cancel the 2 pictures display.

•When the Video input is set to RGB Video, this Split mode is not possible.

•Refer to the table for 2 pictures (Split) mode.

Input terminal		AV1	AV4			AV1, AV2	RGB1	RGB2
	Sub	PAL-N	NTSC-M	576i	480i	1080i/50 1080i/60 720p/60	STB	Component
	Main		PAL-M	576p	480p				Sub
AV1	PAL-N							Main
AV4	NTSC-M , PAL-M
	576i, 576p
AV1	480i, 480p
	1080i/50
AV2
	1080i/60
	720p/60
RGB1	STB
RGB2	Component
							(
NOTE

•Even if the input of the horizontal / vertical synchronizing signal (or video signal) stops in the MULTI PICTURE display, the mode will not change to power save mode.

•Please be careful since image retention will occur if display is left in a MULTI PICTURE display state for a long period of time.

Input Signal Screen Display

The input signal status can be displayed on the screen by pressing the RECALL button of the remote control or the monitor.

• The display will go out in approximately 6 seconds.

VIDEO

Off-timer

On-timer

OFF

ON

-- -- Min.

---- : -- --

AV1 Input mode

Composite Signal mode