RECEPTION PROBLEMS
| • IGNITION NOISE: |
|
| Black spots or horizontal streaks may appear, picture may flutter or drift. Usually |
|
| caused by interference from automobile ignition systems, neon lamps, electrical drills, |
|
| and other electrical appliances. |
|
|
| English |
| Ghosts are caused by the television signal following two paths. One is the direct path | |
| • GHOSTS: |
|
| and the other is reflected from tall buildings, hills or some other objects. Changing the |
|
| direction or position of the antenna may improve reception. Ghosting may also be |
|
| caused by defects in the antenna system such as unshielded leads or connecting |
|
| several sets to the same antenna without using multiple antenna couplers. | Français |
| • SNOW: | |
|
| |
| If your receiver is located in the fringe area of a television station where the signal is |
|
| weak, your picture may be marred by the appearance of small dots. When the signal |
|
| is extremely weak, it may be necessary to install a special antenna to improve the |
|
| picture. |
|
|
|
|
| • RADIO FREQUENCY INTERFERENCE: |
|
| The interference produces moving ripples or diagonal streaks, and in some cases, |
|
| causes loss of contrast in the picture. |
|
| • PREVENTION OF AN OBSTACLE TO RADIO RECEIVERS |
|
| This PDP TV has been designed pursuant to the FCC class B Rules. This is to prevent |
|
| a problem to Radio receivers. If this PDP TV causes a problem to Radio receivers, |
|
| then take the following steps: |
|
| - Keep the PDP TV away from Radio. |
|
| - Adjust Radio antennas in order for the PDP TV not to receive interference. |
|
| - The antenna cable of Radio should be kept away from the PDP TV. |
|
| - Use a coaxial cable for antenna. |
|
| You can check if this PDP TV influences Radio receivers by turning off all other |
|
| equipment other than the PDP TV. |
|
| If you find a problem receiving Radio when using the PDP TV, check the instructions |
|
| mentioned above. |
|
• The display image appears | • Adjust the horizontal clock and clock phase. |
|
scrolling diagonal. | (Adjust the horizontal clock first, the clock phase next.) |
|
• Text displayed across the screen | (RGB input) |
|
appears vertically streaked, with |
|
|
the characters in vertical columns |
|
|
blurred. |
|
|
|
|
|
• Text displayed across the | • Adjust the clock phase for the clearest viewing. |
|
screen appears blurred. | (RGB input) |
|
• A fine pattern flickers when |
|
|
displayed on the screen. |
|
|
|
|
|
• Vertical stripes appear, depending on the | • The plasma display panel is lighting the phosphors by the discharge of internal |
|
screen contents. | radiation. Depending on the screen contents, in rare cases this may cause vertical |
|
| stripes to appear because of failure to light. Please note that this is not a malfunction. |
|
• Coarse horizontal stripes appear in FULL | • Adjusting the clock phase will reduce the horizontal stripes. |
|
display. | (RGB input) |
|
|
|
|
• The display dims to make the picture invisible | • This condition may occur when the unit is connected to a VCR with component |
|
during special playback of a VCR (FF, REW). | output, such as 480i, but it is not a failure. But when it occurs, switch to composite |
|
| output. |
|
41
