USING THE REMOTE TO CONTROL CABLE BOX FUNCTIONS | - 21 - |
NOTES:
1.If your VCR cannot be operated after performing the above procedures, this means that your VCR's codes have not been precoded into the remote.
2.In the unlikely event that your VCR cannot be operated after performing the above procedures, please consult your VCR operating guide.
3.The remote control will remember the codes you have programmed in until the batteries are removed from the remote control. After replacing the batteries repeat the entire programming procedure stated above.
4.If your VCR does not have a power function, the remote will issue the CHANNEL UP function.
Remote Control Buttons
QVCR BUTTON
This button allows the remote to control your VCR by setting it to VCR mode.
RPRECODED VCR BUTTONS
These buttons transmit the chosen precoded VCR codes. For some VCR's, you must press the RECORD button twice to record a program.
SEXCLUSIVE TV BUTTONS
These buttons are for operating the TV.
USING THE REMOTE TO CONTROL CABLE BOX FUNCTIONS
Operating the pre-coded function for your cable box
This remote is designed to operate different types of cable boxes. You must first program the remote to match the remote system in your cable box. (Refer to page 22)
1.Turn ON your cable box.
2.Aim the remote control at the front of your cable box.
3.While holding down the CABLE button, enter the 2 digit preset code that matches your cable box as shown on page 22. The remote will turn off your cable box when the correct 2 digit preset code is entered. When this occurs, the remote control is programmed for your cable box. If the cable box does not turn off after 5 seconds, try another 2 digit preset code.
4.The remote will now control your cable box.
NOTES:
1.If your cable box cannot be operated after performing the above procedures, this means that your cable box codes have not been precoded into the remote.
2.In the unlikely event that your cable box cannot operate after performing the above procedures, consult your cable box operating guide.
3.The remote control will remember the codes you have programmed in until the batteries are removed from the remote control. After replacing the batteries repeat the entire programming procedure stated above.
4.If your cable box does not have a power function, the remote will issue the CHANNEL UP function.