USING THE REMOTE TO CONTROL VCR FUNCTIONS

- 20 -

PIP Swap Illustration

NOTE:

1.The SWAP button will only operate when SINGLE PIP mode is chosen.

2.The SWAP function will not operate if ANT B input is set as the main channel (ANT B input cannot be displayed as a sub-picture.)

3MOVE button

To move the sub-picture to another corner, press the MOVE button. The sub-picture moves one step counterclockwise every time the MOVE button is pressed. (Example below illustrates the MOVE operation for initial shipping conditions. If you have customized a PIP position, the MOVE operation may differ slightly from this example.)

PIP Move Illustration

It is also possible to customize the PIP position. To do this, wait until the On-Screen Display disappears (about eight seconds) and the use the CURSOR , , , buttons.

PIP Move Illustration

4FREEZE (FRZ) button (With PIP ON)

If you wish to freeze the sub-picture, press the FRZ button. This is convenient when trying to write down the address for a mail order company, recording statistics for a sporting event, etc. To return the picture to motion, press the FRZ button again.

NOTE: The FREEZE function will only operate when SINGLE PIP mode is chosen.

5FREEZE (FRZ) button (With PIP OFF)

Press the FRZ button to freeze one or four frames of the picture, depending on the mode previously selected (SINGLE or STROBE). To change FREEZE modes, use cursor or to select which type of FREEZE mode you wish to view. The new selection will appear the next time the FREEZE function is used.

SINGLE FREEZE

Press the FRZ button to freeze one frame of the picture you are currently viewing. Press this button again or PIP to return to normal viewing.

Single Freeze Illustration

STROBE FREEZE

Press the FRZ button to freeze four frames of the picture you are currently viewing. Press this button again or PIP to return to normal viewing. This feature is useful for viewing a moving picture that has many details, for example, a close play in a sporting event or golf swing.

Strobe Freeze Illustration

CAUTION: A pattern burn may develop if the sub-picture is left in the same corner permanently. If the PIP feature is used frequently, occasionally MOVE the sub-picture to a different

corner. You may also vary its position using the CURSOR , , , or buttons.

NOTE:

1.Only sound from the main picture can be heard, unless you choose sub-picture audio from THEATER-WIRELESS SOUND mode and use the WIRELESS OUT outputs on the rear panel. (See page 55.)

2.Each freeze frame is delayed about 0.1 (1/10) second.

3.The FREEZE function will display blank sub-pictures when the COMPONENT Y-CbCr Input 2 source is set as main channel.

USING THE REMOTE TO CONTROL VCR FUNCTIONS