USING THE REMOTE TO CONTROL CABLE BOX/SATELLITE FUNCTIONS - 21 -

Operating the precoded function for your VCR.

This remote is designed to operate different types of VCRs. You must first program the remote to match the remote system of your VCR. (Refer to page 30.)

1.Set the MULTI-PAGE select switch to VCR.

2.Turn ON your VCR.

3.Aim the remote control at the front of your VCR.

4.Hold down the PROG button on the remote, enter the two digit preset code that matches your VCR as shown on page 30. The remote will turn off your VCR when the correct two digit preset code is entered. When this occurs, the remote control is programmed for your VCR. If the VCR does not turn off after five seconds, try a different two digit preset code.

5.The remote will now control your VCR.

NOTES:

1.If your VCR cannot be operated after performing the above procedures, your VCR's code has not been precoded into the remote.

2.In the unlikely event that your VCR cannot be operated after performing the above procedures, please consult your VCR operating guide.

3.The remote control will remember the codes you have programmed until the batteries are removed from the remote control. After replacing the batteries repeat the entire programming procedure as stated above.

4.If your VCR does not have a power function, the remote will issue the CHANNEL UP function.

5.The MENU button will act as the VCR MENU button for HITACHI VCRs.

6.The LST-CH button will act as your VCR ENTER button if required.

7.The SLEEP button will act as your VCR '100' button if required.

8.The REC button must be pressed two times to begin VCR recording. This button will also act as the VCR record button when the remote is in CABLE or DSS mode.

Remote Control Illustration.

1PRECODED VCR buttons

These buttons transmit the chosen precoded VCR codes.

2EXCLUSIVE TV buttons

These buttons are for operating the TV.

USING THE REMOTE TO CONTROL CABLE BOX/SATELLITE FUNCTIONS

Operating the precoded function for your cable/satellite box.

This remote is designed to operate different types of cable boxes and satellite systems. You must first program the remote to match the remote system in your cable/satellite box. (Refer to page 30.)

1.Set the MULTI-PAGE select switch to TV/CABLE/DSS.

2.Turn ON your cable/satellite box.

3.Press the CABLE button on the remote to switch to CABLE mode, or the DSS button to switch to DSS mode.

4.Aim the remote control at the front of your cable/satellite box.

5.Hold down the CABLE/DSS button on the remote, enter the two digit preset code that matched your cable/satellite box as shown on page 30. The remote will turn off your cable/satellite box when the correct two digit preset code is entered. When this occurs, the remote control is programmed for your cable/satellite box. If the cable/satellite box does not turn off after five seconds, try another two digit preset code.

6.The remote will now control your cable/satellite box.

NOTES:

1.If your cable/satellite box cannot be operated after performing the above procedures, your cable/satellite box code has not been precoded into the remote.

2.In the unlikely event that your cable/satellite box cannot be operated after performing the above procedures, please consult your cable/satellite box operating guide.

3.The remote control will remember the codes you have programmed until the batteries are removed from the