Hitachi 53UWX10BA Picture-In-Picture Pip, PIP button, Single Mode PIP

PICTURE-IN-PICTURE (PIP)

Your HITACHI Projection TV incorporates Dual Tuner technology designed for improved viewing enjoyment. This Dual Tuner feature allows you to view antenna inputs on both the main picture and sub-picture simultaneously, with separate tuning control for each. The Dual Tuner can operate with only one input (ANT A only) or two inputs (ANT A and ANT B).

ANT A input can be viewed as both the main picture and the sub-picture simultaneously. ANT B can only be viewed as a main picture. To select between main picture and PIP sub-picture tuning, press the PIP CH button on the remote. The highlighted channel display will move with every press of the PIP CH button. When the top channel display is highlighted, channel tuning is for the main picture. When the lower channel display is highlighted, channel tuning is for the PIP sub-picture.

The Picture-in-Picture feature is convenient when you want to watch more than one program at the same time. You can watch a TV program while viewing other programs from the ANT A source or any of the video inputs.

Models: 61UWX10BA, 53UWX10BA, 43UWX10B

ANT A
TO
CONVERTER
	S-VIDEO	S-VIDEO			S-VIDEO
ANT B	VIDEO	VIDEO	Y/VIDEO	Y/VIDEO	VIDEO

		(MONO)	(MONO)	PB	(MONO)	PB	(MONO)	L
		L	L		L		L
				PR		PR
AUDIO TO HI-FI		R	R		R		R	R
R	L	AUDIO	AUDIO		AUDIO		AUDIO	AUDIO

INPUT 1 INPUT 2	INPUT 4	INPUT 5	MONITOR
			OUT

Back of

VCR

V L R

OUTPUT

VCR

Hitachi Model or

Similar Model

Models: 61SWX10B, 61SWX12B 53SWX10B, 53SWX12B

OPTICAL	COAXIAL		STOP
INPUT	INPUT	ANT A

	MENU		EXIT
VOL		SELECT			CH
SVCS	MUTE		STATUS		SCHD
VCR	PLUS+
VID1			INFO	GUIDE/TV	VID	5
VID 2			VID 3	VID	4
PIP		PIP CH			FREEZE	,
			PIP ACCESS
PIP MODE		SWAP
PROG		TV/VCR			SLOW

TO

REAR SPEAKER CONVERTER

L

ANT B

	R
AUDIO TO HI-FI		SUB
		WOOFER
R	L

Back of

VCR

V L R

OUTPUT

VCR

Hitachi Model or

Similar Model

CONNECT ONLY 8 OHM SPEAKERS

DO NOT SHORT CIRCUIT

THESE TERMINALS

(Such damage is NOT COVERED by your television warranty)

S-VIDEO S-VIDEO

VIDEO	VIDEO	Y/VIDEO
(MONO)	(MONO)	PB	(MONO)
L	L		L
		PR
R	R		R
AUDIO	AUDIO		AUDIO
INPUT 1	INPUT 2	INPUT 4

		S-VIDEO	REC
Y/VIDEO		VIDEO
PB	(MONO)	L
	L
PR
	R	R
	AUDIO	AUDIO
INPUT 5		MONITOR
		OUT

Use above connection to view VCR program as a sub-picture while viewing another program as main picture (ANT A, ANT B, V:2, V:3, V:4, or V:5). You may also view the VCR program as a main picture while viewing another program as a sub-picture (ANT A, V:2, V:3, V:4, or V:5).

PIP button

Press the PIP button and a sub-picture will appear in one of the three different modes (SINGLE, SPLIT or SURF), depending on the last selection of the PIP mode. To change the PIP mode, use the PIP MODE button to cycle through the three different modes.

SINGLE MODE PIP

Press the PIP button and a sub-picture appears in one of the three different modes (SINGLE, SPLIT or SURF), depending on the last selection of the PIP mode. Press the PIP button again to remove the sub-picture from the screen. Use the PIP CH button to select between main and sub-picture tuning control (indicated by gray highlighted channel display.) Press the VID1, VID2, VID3, VID4 or VID5 button when sub-picture channel tuning is being controlled, to change between VIDEO: 1, VIDEO: 2, VIDEO: 3, VIDEO:4 and VIDEO:5 and ANT:A source. (ANT B source cannot be viewed as a sub-picture.)

PIP

Ant A 10

Use Thumb Stick to move PIP inset.

Ant A 12

Main Picture

PIP

Sub Picture

Ant A 10

NOTES: 1. When using Y-PBPRinput, only 480i signal can be viewed as a single mode PIP.

2.When ANT B is selected as the main channel, the SWAP feature is disabled.

3.Only sound from the main picture can be heard.

4. In SINGLE PIP mode, thumb stick CURSOR , will move the sub picutre up/down.

27