Hitachi 55HDT79 42HDX99 important safety instructions To Power Swivel Connector, CableCARD Slot

Rear Panel Connections

￿IEEE1394 (DV INPUT) (Only for HDX models) These jacks provide a digital interface for your external digital devices, such as a Digital VCR (D- VHS), Set-Top-Box or Digital Camcorder by means of a single cable (see page 24). When using IEEE1394 connections, you enable video and audio digital data exchange between a compatible device. This connection also enables you to control basic equipment functions (such as VCR play, rewind, fast forward, stop, etc.) from your TV On-Screen Display.

￿Upgrade Card

This card slot is for future software upgrades. Hitachi will notify you if a software upgrade is required for your TV. In order to receive written notification, please complete and return your warranty card.

￿To Power Swivel Connector

Connects to the Power Swivel Table Top Stand.

￿CableCARD Slot

This slot is for the CableCARD that will be provided by your local cable operator to gain access to chosen cable channels. The CableCARD will allow you to tune digital and high definition cable channels. Please call your local cable operator if this service is available before requesting a CableCARD (also known as Point of Deployment (POD) module).

1.Connect a coaxial cable to cable terminal of the Rear Panel Jacks.

2.Insert the CableCARD into the slot (Top of card should be facing towards you as shown below).

If the CableCARD is properly installed or removed, the TV will display the following respective screens.

CableCARD is installed

OR

CableCARD is not installed

After the CableCARD is installed, wait until the second screen below appears.

Acquiring Data.

Please wait.

First time use

Digital Cable

INSERT

In order to start cable service for this device, please contact your cable provider

CableCARD(tm): 123-456-789-1

Host: 123-456-789-1

Data: 123-456-789-1

Unit Address: 123-456-789-1

Press EXIT to return

NOTE: 1. A digital cable subscription is required.	Please take note of all information on the screen (you
	will provide this information to your cable operator).
2. Do not insert a PCMCIA card into the
CableCARD slot.	Call your cable operator and give them the information
	from the card to start your cable service.

13