Hitachi 55HDT79 42HDX99 important safety instructions Accessories, For U.S. models

Press down and slide back to remove.

Accessories

Check to make sure you have the following accessories before disposing of the packing material.

First time use

￿Remote Control

+

-

/

￿ Simple Remote		￿ Power Cord	￿ 2 IR Blaster Cables
	GUIDE
	CH +
VOL -	VOL +
	SELECT
MUTE	FAV CH
	CH -
MENU	INPUTS

EXIT

￿ Ferrite Core on AC Cord

POWER	(Only 55” models)
	￿Power Swivel Cable

￿Two “AA” size,

1.5V batteries

￿ Table Top Stand	￿1 Ferrite Core
	(see page 14)
(42” models only)
￿ Two “AAA” size,
1.5V batteries
	Note: Please visit our
For U.S. models:	website for optional
For optional accessories, please access our web site at:	accessories.
www.hitachi.us/tv

CAUTION: 1. Ceiling mounting is not recommended. Mounting the panel on the ceiling does not provide adequate ventilation for the electronics or proper support for the front glass panel. This plasma television product is designed for a maximum tilting angle of 45 degrees from vertical.

2.This stand for use only with Hitachi 42HDX99 and 42HDT79. Use with other apparatus is capable of resulting in instability causing possible injury. See important marking located on bottom of stand.

￿ Remote Control Unit CLU-3861WL	￿ Power Cord (P# EV01841).
(Part No. HL02069).	￿ Two IR Blaster cables (P# EY01641).
￿ Simple Remote Control Unit CLU-123S	￿ Table Top Stand (QJ02681 HDT) (QJ02673 HDX) 42" models only.
(Part No. HL01864)(HDX models only).	￿ Ferrite Core (P# GX00666) (Only 55" models AC Cord)
￿ Two “AA” size, 1.5V batteries (P# FQ00021).	￿ Power Swivel Cable (P# EW08432).
￿ Two “AAA” size, 1.5V batteries (P# FR00061)	￿ 1 Ferrite Core (P#2169513).

REMOTE CONTROL BATTERY INSTALLATION

AND REPLACEMENT

BOTTOM VIEW	BOTTOM VIEW
(Remote Control)	(Simple Remote Control)

1.Open the battery cover of the remote control by

pushing down and sliding the back cover off.

2.Insert two new “AA” and “AAA” size batteries for the remote control and Simple Remote Control.

When replacing old batteries, push them towards the springs and lift them out.

3.Match the batteries to the (+) and (-) marks in the battery compartment.

4.Replace the cover.

Lift up on tab to remove back cover.

CAUTION: Do not insert batteries with the ‘+’and ‘-’ polarities reversed as this may cause the batteries to swell or rupture resulting in leakage.

4