THE GENIUS REMOTE TO LEARN ADDITIONAL

2.Set the LEARN/USE mode select switch located on the back of the Genius Remote to the LEARN position.

3.Set the MULTI-PAGE select switch to "USER" position.

4.Press one of the learnable buttons on the Genius Remote, ("7" in this example). This button will be used to store the new code. The READY indicator will flash at this time. (The light will remain lit for approximately 15 seconds. If no other function is performed at this time, the operation is canceled.)

5.Press and hold the button down on the other transmitter which contains the code to be stored, while the READY light is lit.

Release the button after both the READY indicator goes out and the LEARN indicator lights.

When storing has been performed correctly, the LEARN indicator lights for about 2 seconds.

If the storing was not done correctly, or the codes are too long to learn, or no more codes can be stored in memory due to memory overflow, the LEARN indicator will not light.

6.Set the LEARN/USE mode select switch on the back of the Genius Remote to "USE" and check that the button to which the code is stored operates correctly.

If it does not operate correctly, repeat from step 1.