(2)Lower the motor head, and thrun the 8mm depth adjustment bolt by hand and make adjustments so that there can be a clearance of 2mm to 3mm (3/32" to 1/8") between the lower limit position of the motor head and the top of the workpiece at the saw blade's lower limit position (where the head of the 8mm depth adjustment bolt contacts the gear case.

(3)After adjustment, turn the 8mm wing nut until it contacts the Hinge (see Fig. 10-b), and fully tighten it.

5.Confirmation for use of sub fence

WARNING: In the case of left bevel cutting, turn the sub fence counterclockwise.

Unless it is turned counterclockwise, the main body or saw blade may contact the sub fence, resulting in an injury.

Left bevel

Right bevel angle

angle cutting

cutting

Turn

Direct angle cutting

 

Sub Fence

Fence (B)

Fig. 11

This power tool is Equipped with a sub fence.

In the case of direct angle cutting and right bevel angle cutting, use the sub fence. Then, you can realize stable cutting of the material with a wide back face.

In the case of left bevel cutting, raise the sub fence up as illustrated in Fig. 11 and then turn it counterclockwise.

6.Oblique angle

Before the power tool is shipped from the factory, it is adjusted for 0°, right angle, left 45° bevel cutting angle and right 45° bevel cutting angle with the 8mm bolt (A), 8mm bolt (B) and the 8mm bolt (C).

When changing the adjustment, change the height of the 8mm bolt (A), 8mm bolt (B) or the 8mm bolt (C) by turning them.

When changing the bevel angle to the right 45°, pull the fixing pin on the direction shown in Fig. 12-a and incline the motor head to the right.

When adjusting the motor head to 0°, always return the fixing pin to its initial position as shown in Fig. 12-b.

8mm Bolt (C) (Stopper for left 45° bevel angle)

Indicator

8mm Bolt (A)

(For right bevel scale)

(Stopper for 0°)

Fixing Pin

PullReturn

Indicator

(For left bevel Fixing Pin scale)

Fig. 12-a

8mm Bolt (B) (Stopper for right 45° bevel angle)

Fig. 12-b

13