7.Securing the workpiece
WARNING: Always clamp or vise to secure the workpiece to the fence; otherwise
the workpiece might be thrust from the table and cause bodily harm.
8. Installing the holders ... (Optional accessory)
Holder | 6mm Knob Bolt | |
(Optional | ||
(Optional accessory) | ||
accessory) |
|
Steel Square
6mm Wing | Base Surface | |
Nut | Height Adjustment | |
(Optional | ||
Bolt 6mm | ||
accessory) | ||
(Optional accessory) | ||
| Fig. 13 |
The holders help keep longer workpieces stable and in place during the cutting operation.
(1)As indicated in Fig. 13, use a steel square for aligning the upper edge of the holders with the base surface.
Loosen the 6mm wing nut. Turn a height adjustment bolt 6mm, and adjust the height of the holder.
(2)After adjustment, firmly tighten the wing nut and fasten the holder with the 6mm knob bolt (optional accessory). If the length of Height Adjustment Bolt 6mm is insufficient, spread a thin plate beneath. Make sure the end of Height Adjustment Bolt 6mm does not protrude from the holder.
9. Stopper for precision cutting ... (Stopper and holder are optional accessory)
Stopper
(Optional accessory)
Workpiece | Holder | |
(Optional accessory) | ||
|
The stopper facilitates continuous precision cutting in lengths of 280mm to 450mm (11" to
| 6mm Wing Nut | |
Move | (Optional accessory) | |
Height | ||
| ||
6mm Knob Bolt | Adjustment Bolt | |
6mm (Optional | ||
(Optional accessory) | ||
accessory) | ||
| ||
Fig. 14 |
|
14