10. Confirmation for use of sub fence (A)…(Optional accessory)

WARNING: In the case of right bevel cutting, remove the sub fence (A). Supposing it is not able to remove it, It will contact the blade or some part of the tool, causing in serious injury to operator.

Sub Fence (A)

6mm Knob Bolt

Fig. 15

In the case of direct angle cutting and angle cutting, use the sub fence (A). The sub fence (A) can be installed on the right side of the guide fence. Insert the rods of the sub fence (A) into the holes in the guide fence. Tighten the 6mm knob bolt which come with the sub fence (A) to secure the sub fence

(A). Then, you can realize stable cutting of the material with a wide back face.

11.Using an ink line

Saw Blade Groove

Guard

6mm Knob Bolt

(1)Right angle cutting

Loosen the 6mm knob bolt and contact the tip of the guard with the workpiece.

Aligning the ink line on the workpiece with the groove of the guard, the workpiece is cut on the ink line (Fig. 16).

WorkpieceMarking

(pre-marked)

Fig. 16

6mm Knob Bolt

Move the

Guard

Backward

Lower Guard

(2)Miter cutting and compound cutting (Miter cutting + bevel cutting)

Upon lowering the motor section, the lower guard is raised and the saw blade appears. Align the ink line with the saw blade (Fig. 17).

Fence (B)

Marking (pre-marked)

Fig. 17

CAUTION: In some arrangements when the turntable is rotated, the guard projects from the fence surface. Loosen the 6mm knob bolt and push the guard to the retracted position. Never lift the lower guard while the saw blade is rotating. When cutting at an angle of 35° to the right or more, please slide the guard to the rear.

The guard and sub-fence will not only make contact and adversely affect cutting accuracy, this could also result in damage to the guard.

15