6mm Bolt Holder

PREPARATION BEFORE OPERATION

Make the following preparations before operating the power tool:

1. Installation

150mm

(5-29/32")

9mm

(11/32") 3 Holes

300mm (11-13/16")

Base 8mm (5/16") Bolt

264mm (10-13/32")

25mm(1") thickbench

Work Bench

8mm (5/16") Nut

Fig. 4

 

Attach the power tool to a level, horizontal work bench in accordance with Fig. 4. Select 8mm (5/16") diameter bolts suitable in length for the thickness of the work bench. Bolt length should be at least 40mm (1-9/16") plus the thickness of the work bench. For example, use 65mm (2-9/16" ) or larger bolts for a 25mm (1") thick work bench. The holder attached to the rear of the base helps stabilize the power tool.

Holder adjustment:

Loosen the 6mm bolt with the supplied 10mm box wrench.

Adjust the holder until its bottom surface contacts the work bench surface.

After adjustment, firmly tighten the 6mm bolt.

Move

Adjust the holder until its bottom surface contacts the work bench surface.

Fig. 5

 

2. Releasing the locking pin

 

Handle

When the power tool is prepared for shipping, its

main parts are secured by a locking pin.

 

Move the handle slightly so that the locking pin

 

can be disengaged.

 

NOTE: Lowering the handle slightly will enable

 

you to disengage the locking pin more

Pull

easily and safely.

Locking Pin

The lock position of the locking pin is for

carrying and storage only.

 

Fig. 6

 

8