OPERATING PROCEDURES
Fuel (Fig. 1)
WARNING
The hedge trimmer is equipped with a two- stroke engine. Always run the engine on fuel, mixed with oil.
Provide good ventilation, when fueling or handling fuel.
Fuel
○ Always use branded 89 octane unleaded gasoline.
○ Use genuine
○ If genuine oil is not available, use an
○ Never use
○ Always mix fuel and oil in a separate clean container.
Fig. 1
Always start by filling half the amount of fuel, which is to be used. Then add the whole amount of oil. Mix (shake) the fuel mixture. Add the remaining amount of fuel.
Mix (shake) the
Fueling
WARNING (Fig. 2)
○ Always shut off the engine before refueling.
○ Slowly open the fuel tank (1), when filling up with fuel, so that possible
○ Tighten the fuel cap carefully, after fueling.
○ Always move the unit at least 3 m from the fueling area before starting.
1
Fig. 2
Before fueling, clean the tank cap area carefully, to ensure that no dirt falls into the tank. Make sure that the fuel is well mixed by shaking the container, before fueling.
Starting
CAUTION
Before starting, make sure the cutting attachment does not touch anything.
1. Set ignition switch (2) to ON position (A). (Fig. 3)
* Push priming bulb (4) several times so that fuel flows through the bulb or return pipe. (If so equipped) (Fig. 4)
2
3
A
Fig. 3
4
Fig. 4
2.With the throttle trigger lockout (3) pressed, pull throttle trigger, then slowly release throttle the trigger first, then the throttle trigger lockout. This will lock the throttle in starting position. (Fig. 3)
3.Set choke lever (5) to CLOSED position (B). (Fig. 5)
B C
5
Fig. 5
4.Pull recoil starter briskly, taking care to keep the handle in your grasp and not allowing it to snap back. (Fig. 6)
6
000Book_CH50EA3_ENG.indb 6 | 2009/12/21 17:35:38 |
|
|
|
|
|
| ||
|
|
| ||
|
|
|
|
|