Communication settings, Operating Guide | Hitachi CP-AW250N instruction

Network Bridge Communication (continued)

Communication settings

For communication setting, use the OPTION - SERVICE - COMMUNICATION menu. (&OPTION menu - SERVICE - COMMUNICATION in the User's Manual

- Operating Guide)

Item

Condition

BAUD RATE	4800bps / 9600bps / 19200bps / 38400bps
Data length	8 bit (fixed)
PARITY	NONE/ODD/EVEN
Start bit	1 bit (fixed)
Stop bit	1 bit (fixed)
Transmission method	HALF-DUPLEX/FULL-DUPLEX

NOTE • For connecting the projector to your devices, please read the manual for each devices, and connect them correctly with suitable cables.

•Turn off (the power of ) both the projector and other devices and unplug , beore connecting them.

•For details of Transmission method, refer to 6.4 Transmission method

-Network Guide.

16

Image 16

Hitachi CP-AW250N user manual Communication settings, Operating Guide

Contents

Example of computer signal CP-AW250N Initial set signals Connection to the ports Computer IN1, B Computer IN2, C Monitor OUT Video SDA SCLCEC USB Type a To input component video signal to Computer in ports Connection RS-232C Communication Communicaion settings CRC Response code / Error code h shows hexadecimal Command Control via the Network Communicaion Port Port1 Port Command control settings TCP #9715 Command format Authentication Automatic Connection Break Network Bridge Communication Communication settings Operating Guide RS-232C Communication / Network command table Gamma Color Temp Gain RGain G Gain B Offset B Color Temp Offset BColor Tint Phase Auto AdjustSize Execute Hdmi Range Computer IN1Computer IN2 Frame Lock Perfect Auto ECO ECO Mode VolumeMirror Monitor OUT Volume Hdmi Volume LANVolume USB Type a MIC Volume Hdmi AudioMIC Level Language Menu Position HMenu Position H Menu Position Power on Auto PowerTemplate Display MY BUTTON-1 MY BUTTON-2 MY Source Remote FreqNormal High PJLink command Avmt ? Lamp ?