MAINTENANCE

Lamps

Electric shock

High temperature

Mechanical shock

Contact your dealer before replacing the lamp.

(Product name: Projector lamp /Model name: DT00301)

Before replacing the lamp, switch power OFF, remove the power cord from the power outlet, and wait approximately 45 minutes until the lamp has cooled. The lamp may explode if handled at high temperatures.

*For disposal of used lamp, treat according to the instruction of community authorities.

*Since the lamp is made of glass, do not apply shock to it and do

not scratch it.

Lamp

* Also, do not use old lamp. This could also cause explosion of the

 

 

lamp.

 

 

* If it is probable that the lamp has exploded (explosive sound is

 

 

heard), disconnect the power plug from the power outlet and ask

 

 

your dealer to replace lamp.

 

 

The lamp is covered by front glass and air-tight structure, but, in

Reflector

Front

rare cases, the reflector and the inside of the projector may be

 

glasss

damaged by scattered broken pieces of glass, and broken pieces

 

 

 

could cause injury when being handled.

Lamp Life

Projector lamps have a finite life. The image will become darker, and hues will become weaker, after a lamp has been used for a long period of time.

Replace the lamp if the LAMP indicator is red, or the CHANGE THE LAMP message (see Table 1.8) appears when the projector is switched ON.

The LAMP is also red when the lamp unit reaches high temperature. Before replacing the lamp, switch power OFF, wait approximately 20 minutes, and switch power ON again. If the LAMP indicator is still red, replace the lamp.

1-16

Page 16
Image 16
Hitachi CP-S220W user manual Maintenance, Lamps, Lamp Life, Electric shock High temperature Mechanical shock