Hitachi CP-X3010Z, CP-X2011, CP-X3511, CP-X2511 Connecting power supply, Turning on the power

Connecting power supply

1. Put the connector of the power cord into the AC IN (AC inlet) of the projector.

2. )LUPO\SOXJWKHSRZHUFRUG¶VSOXJLQWRWKH outlet. In a couple of seconds after the

power supply connection, the POWER indicator will light up in steady orange.

3OHDVHUHPHPEHUWKDWZKHQWKH',5(&721IXQFWLRQ
activated, the connection of the power supply make the	AC IN	Power cord
projector turn on.

WARNING ŹPlease use extra caution when connecting the power cord, as LQFRUUHFWRUIDXOW\FRQQHFWLRQVPD\UHVXOWLQ¿UHDQGRUHOHFWULFDOVKRFN ‡2QO\XVHWKHSRZHUFRUGWKDWFDPHZLWKWKHSURMHFWRU,ILWLVGDPDJHGFRQVXOW your dealer to get a new one. ‡2QO\SOXJWKHSRZHUFRUGLQWRDQRXWOHWZKRVHYROWDJHLVPDWFKHGWRWKHSRZHU cord. The power outlet should be close to the projector and easily accessible. Remove the power cord for complete separation. ‡1HYHUPRGLI\WKHSRZHUFRUG

Turning on the power

1. 0DNHVXUHWKDWWKHSRZHUFRUGLV¿UPO\ and correctly connected to the projector

and the outlet.

2. Make sure that the POWER indicator is steady orange. Then remove the lens

cover.

3. Press the STANDBY/ON button on the projector or the remote control.

The projection lamp will light up and the POWER indicator will begin blinking in green. When the power is completely on, the indicator will stop blinking and light in steady green.

STANDBY/ON button POWER indicator

MY SOURCE/

VIDEO COMPUTER DOC.CAMERA

ASPECT AUTO SEARCH BLANK

MAGNIFY FREEZE PAGE VOLUME

UP

ON

DOWN

OFF

KEYSTONE MY BUTTON MUTE

1 2

POSITIONMENU

ENTER

ESCRESET

WARNING Ź$VWURQJOLJKWLVHPLWWHGZKHQWKHSURMHFWRU¶VSRZHULVRQ'R not look into the lens of the projector or look inside of the projector through any of the projector’s openings.

NOTE‡3OHDVHSRZHURQWKHSURMHFWRUSULRUWRWKHFRQQHFWHGGHYLFHV ‡7KHSURMHFWRUKDVWKH',5(&721IXQFWLRQZKLFKFDQPDNHWKHSURMHFWRU DXWRPDWLFDOO\WXUQRQ)RUPRUHLQIRUPDWLRQSOHDVHVHHWKH³2SHUDWLQJ*XLGH´ in the CD.

8