Hitachi CP-X251 user manual Component, VIDEO ports, Cb/Pb, Cr/Pr

			Part names
	Power switch (		17)
		AC inlet (	14)
Ports (See below.)		Elevator button (		9)
				9)
		Elevator foot (
Rear-Left side	Vent (	7)

AUDIO IN3 L/R port (13) (In the default setting, the AUDIO IN3 L/R port is the audio port for the VIDEO, S-VIDEO and COMPONENT VIDEO ports, however it is possible to change the settings. 36)

AUDIO IN1 port (12)

(In the default setting, the AUDIO IN1 port is the audio port for the RGB IN1 port, however, it is possible to change the settings. 36)

RGB IN1 port (12)

Restart switch (*) (58)

RGB IN2 port (12)

RGB OUT port (12)

COMPONENT	13)	Y	R
VIDEO ports (
			AUDIO IN3
Y			RGB IN1	RGB IN2 RGB OUT AUDIO OUT
CB/PB
		CB/PB	AUDIO IN1
CR/PR			L
		CR/PR	AUDIO IN2
			K	CONTROL
VIDEO port (	13)	VIDEO		USB

S-VIDEO

S-VIDEO port ( 13)

USB port (

AUDIO OUT port (12)

Ports

12)

AUDIO IN2 port (12)

(In the default setting, the AUDIO IN2 port is the audio port for the RGB IN2 port, however, it is possible to change the settings.

36)

CONTROL port (

Kensington lock slot

12)

NOTE (*) About Restart switch: This projector is controlled by an internal microprocessor. Under certain exceptional circumstances, the projector may not operate correctly and the microprocessor will need to be reset. In such a case, please push the Restart switch by using a cocktail stick or similar, and before turning on again, make the projector cool down at least 10 minutes without operating. Only push the Restart switch in these exceptional instances.

5