Hitachi CP-X935W Input, Auto-adjustment, AUTO Confirm Screen, During AUTO-adjustment, English

Adjustments and functions (continued)

< Auto-adjustment >

The projector will automatically adjust four items (V POSIT, H POSIT, H PHASE, H SIZE).

When AUTO is selected (the cursor is moved from Manual Operation towards the right) the AUTO Confirm screen shown below will be displayed.

< AUTO Confirm Screen >

While the AUTO confirmation screen is displayed as illustrated on the upper right, if you shift the cursor upward and select AUTO, the projector will perform auto-adjustment.

It will become as illustrated on the lower right.

If CANCEL is selected for three seconds, or if the RESET button on either the unit or the remote control is pressed, the green cursor will return to the value for the selected item (Manual Operation)

S E T U P I N P U T I M A G E O P T .
VOLUME
BRIGHT
CONTRAST
V POSIT	123	AUTO
H POSIT	AUTO 111
H PHASE	CANCEL
H SIZE	1024
COLOR BAL	R	B

ENGLISH

< During AUTO-adjustment >

At the lower right of the screen the word <AUTO> will flash in green letters.

When the auto-adjustment is completed the word <AUTO> will disappear.

AUTO

Caution	∙ When start up screen is displayed ("NO INPUT IS DETECTED" or "SYNC IS OUT OF
	RANGE" is displayed), SETUP menu items other than VOLUME cannot be set.

∙TINT cannot be adjusted with PAL/SECAM video signal input.

∙TINT, COLOR and SHARPNESS cannot be adjusted with an RGB signal input.

∙V.POSIT, H.POSIT, H.PHASE and H.SIZE cannot be adjusted with a VIDEO signal input.

∙Auto-adjustment will take about 10 to 15 seconds to complete.

∙In some cases auto-adjustment may not function normally, depending on the type of computer to which the unit is connected, and the signal sent.

∙Auto-adjustment may not perform normally with some images. Do not use with animated or dark images.

∙Carry out the auto-adjustment when the application, which is activated on the computer, is set to the maximum display.

∙After auto-adjustment the screen may become slightly dark due to the auto-adjustment of the signal level.

INPUT	The menu INPUT serves for the selection of input source.
	S E T U P		I N P U T	I M A G E O P T .	SETUP		INPUT	IMAGE OPT .
									S Y S T E M
		RGB1				RGB1			AUTO
		RGB2				RGB2			NTSC
		VIDEO				V I DEO			PAL
									SECAM
									NTSC4.43
									M-PAL
									N-PAL

Adjustment Item	Details of adjustment
RGB 1	Selects the RGB 1 terminal.
RGB 2	Selects the RGB 2 terminal.
VIDEO	Selects the VIDEO terminal.
	Selects the video signal systems. In normal circumstances, select AUTO. AUTO does not
SYSTEM	support N-PAL.
	When the picture (Video) is abnormal (no color), selects the input signal mode (NTSC,
	PAL, SECAM, NTSC4.43 M-PAL and N-PAL). To input N-PAL signals, select N-PAL.

17