Hitachi CP-X980W user manual Operations, Power ON, Power OFF, English

OPERATIONS

		STANDBY/	STANDBY/ON	VIDEO
POWER Indicator	STANDBY/ON Button	ON Button	LASER
			BLANK	RGB
FOCUS button	ZOOM button
			AUTO
			MENU	POSITION
			MENU SELECT
Power Switch			PinP	RESET
			FREEZE
			MAGNIFY	VOLUME
		FOCUS button	OFF
				MUTE
			FOCUS ZOOM
	Lens cap	ZOOM button

ENGLISH

Power ON

1.Check that the power cord is connected correctly.

2.Set the power switch to [ ]. The standby mode is selected, and the POWER indicator is turned to orange.

3.Press the STANDBY/ON button on the control panel or the remote control transmitter. Warm-up begins and the POWER indicator blinks in green.

4.The POWER indicator ceases blinking and turns to green when power is on. Remove the lens cap.

5.Adjust picture size using the ZOOM button.

6.Adjust focus using the FOCUS button .

Power OFF

1.Press the STANDBY/ON button on the control panel or the remote control transmitter for approximately two second. The projector lamp is extinguished and lamp cooling begins. The

POWER indicator blinks orange during lamp cooling. Pressing the STANDBY/ON button has no effect while the POWER indicator is blinking.

2.The system assumes the Standby mode when cooling is complete, and the POWER indicator ceases blinking and changes to orange. Check that the indicator is orange and set the Power switch to [O].

3.The POWER indicator is extinguished when power is off. Attach the lens cap.

WARNING • Please read this manual, and the separate “SAFETY INSTRUCTIONS” thoroughly before using the equipment. Always ensure that

the equipment is used safely.

NOTE • Except in emergencies, do not turn off unless the POWER indicator is orange as it will reduce the life of the projector lamp.

•To prevent any troble, turn on/off the projector when the computer or video tape recorder is OFF. Providing a RS-232C cable is connected, turn on the computer before the projector.

ENGLISH-9