Hitachi CPSX5600W user manual Operations, Power on, Power OFF, Equipment is used safely

OPERATIONS

STANDBY/ON Button	STANDBY/	STANDBY/ON	BLANK
(STANDBY/ON Indicator)			LASER
	ON Button
		VIDEO	RGB

		AUTO
Power Switch		MENU	KEYSTONE
		MENU SELECT
	Zoom Knob	POSITION	RESET
		FREEZE	PinP
	Focus Ring	MAGNIFY	MUTE
		OFF

Lens cap

VOLUME

ENGLISH

Power ON

1.Check that the power cord is connected correctly.

2.Set the power switch to [ ]. The standby mode is selected, and the STANDBY/ON indicator is turned to orange.

3.Press the STANDBY/ON button on the control panel or the remote control transmitter. Warm-up begins and the STANDBY/ON indicator blinks in green.

4.The STANDBY/ON indicator ceases blinking and turns to green when power is on. Remove the lens cap.

5.Adjust picture size using the Zoom Knob.

6.Adjust focus using the Focus Ring .

Power OFF

1.Press the STANDBY/ON button on the control panel or the remote controller. Then,the message "Power off?" will appear on the screen, and the message will disappear by any operation

or no operation for 5 seconds. During this message indication, press the STANDBY/ON button again. The projector lamp is extinguished and lamp cooling begins. The STANDBY/ON

indicator blinks orange during lamp cooling. Pressing the STANDBY/ON button has no effect while the STANDBY/ON indicator is blinking.

2.The system assumes the Standby mode when cooling is complete, and the STANDBY/ON indicator ceases blinking and changes to orange. Check that the indicator is orange and set the Power switch to [O].

3.The STANDBY/ON indicator is extinguished when power is off. Attach the lens cap.

Put the Lens cap to the lens properly. In order to do it, keep pushing two knobs on the lens cap, then fit it to the lens holding the cap in horizontal position.

WARNING • Please read this manual, and the separate “SAFETY INSTRUCTIONS” thoroughly before using the equipment. Always ensure that

the equipment is used safely.

NOTE • Except in emergencies, follow the above-mentioned procedure for turning power off. Incorrect procedure will reduce the life of the projector lamp and LCD panel.

•To prevent any troble, turn on/off the projector when the computer or video tape recorder is OFF. Providing a RS-232C cable is connected, turn on the computer before the projector.

ENGLISH-9