English
ASSEMBLY AND OPERATION
APPLICATIONS
Rotation and hammering function
Drilling anchor holes
Drilling holes in concrete
Drilling holes in tile Rotatio n only function
Drilling in steel or wood
Tightening machine screws, wood screws Hammering only function
REMOVAL AND INSTALLATION METHOD OF BATTERY
1.Battery removal
Hold the handle tightly and push the battery latches to remove the battery (See Figs. 3 and 4).
2.Battery installation
Insert the battery aligning both guide rail of battery and body. Make sure the battery is fixed firmly. (See Fig. 4)
Latch | Guide rail of battery |
| |
| Battery |
Fig. 3
Housing Pull out Insert
Guide rail of housing
Fig. 4
CHARGING METHOD
NOTE:
Before plugging into the receptacle, make sure the following points.
The power source voltage is stated on the nameplate.
The cord is not damaged.
WARNING:
Do not charge at voltage higher than indicated on the nameplate.
If charged at voltage higher than indicated on the nameplate, the charger will burn out.
1.Insert the plug of battery charger into the receptacle.
When the plug of battery charger has been inserted into the receptacle, the charge status lamp will blink in red. (At
WARNING:
Do not use the electrical cord if damaged. Have it repaired immediately.
2.Insert the battery to the battery charger.
Insert the battery into the battery charger as shown in Fig. 5. Make sure it contacts until the line is visible.
Before insert
Line
After insert
Fig. 5
11