REMOTE CONTROL OF THE TV
PROGRAMMING THE REMOTE CONTROL OF THE TV
1Turn off the TV.
2Program the remote control
Aim the DVD’s remote control at your TV set. Hold down the TV POWER button while you press the number corresponding to your brand of television as shown in the chart.
For example; If you have a Hitachi television, press the TV POWER and 1 at the same time. If this but- ton combination sends a signal that matches with your TV, the TV will turn on, and you’ll know the remote is set to control the television.
NOTES:
¡If that button combination does not change the TV channel, go through the whole list of button combi- nations one by one until you find one that does change your TV channel.
¡Also, if your brand of TV is not listed in the chart, try all the number buttons. One of them may work for you.
¡If the TV channel still doesn’t change after going through all the button combinations listed, it is likely that you will not be able to program this remote control for your TV.
CONTROLLING THE TV
Once programmed, the DVD’s remote control is ready to control the TV.
NOTE: Be aware that not all of your TV’s functions may work even though the remote control is correctly programmed.
To operate the TV
¡You can turn on your TV by pressing the TV POWER button.
¡You can change the channels with the CH (K) or CH (L) button and the volumes with VOL ( 
) or VOL ( 
) button for the TV.
To operate the DVD
Press the VIDEO/TV button to operate your DVD with the remote.
TV Brands | Press the TV and This Number |
|
|
HITACHI | 1 |
|
|
SONY | 2 |
|
|
RCA | 3 |
|
|
SANYO | 4 |
|
|
ZENITH | 5 |
|
|
PANASONIC1 | 6 |
|
|
PANASONIC2 | 7 |
|
|
SHARP1 | 8 |
SHARP2 | 9 |
TOSHIBA | 0 |
JVC | CLEAR |
MITUBISHI | +10 |
MAGNAVOX | SUBTITLE |
FUNAI | AUDIO |
|
|
GOLDSTAR | DISPLAY |
– 30 – | EN |
1L01
