Hitachi DZMV270A About Stored Data, Removing and Replacing Disc from/in Cartridge or Caddy

Models: DZMV270A

1 114
Download 114 pages 59.91 Kb
Page 24
Image 24

Note: Most generally available 8 cm discs can be removed from cartridges or caddies if they are for video cameras; However, before removing disc from cartridge or caddy, read the instruction sheet provided with the disc or consult the disc maker. Take care with the following when handling the removed disc:

Be sure not to touch disc surfaces.

Be careful not to drop the disc removed from cartridge or caddy.

Be sure not to bend the disc.

Do not leave the disc outside the cartridge or caddy.

Do not subject the disc to heat.

Do not write on disc with a ball-point pen or pen- cil. (With one-side recordable disc, writing on the label surface is possible with a pen that does not scratch the surface. No writing of any kind is pos- sible on both-side recordable disc.)

Be sure not to wipe disc surfaces with thinner, water or anti-static agent.

Use dry, soft cloth to lightly wipe off dust or dirt that adheres to the disc. Never use solvents to clean the disc.

Note: If the disc is removed from cartridge or caddy and the data stored by this DVD video camera/recorder is rewritten on devices other than this DVD video camera/recorder, recording or playback may not be normal, or Disc Naviga- tion may not operate normally, when the disc re- placed in cartridge or caddy is used on this DVD video camera/recorder again.

Note: The cartridge or caddy protects the sur- faces of disc on which high-density recording is possible. Once removed from cartridge or caddy, the disc can be replaced in the cartridge or caddy and used with this DVD video camera/recorder, but be sure to observe the following:

Before replacing the disc in cartridge or caddy,

make sure that disc surfaces are not scratched, and that no dirt or fingerprint adheres to them.

•Do not record, edit or delete on the disc when scratches, dirt or fingerprints cannot be removed even if disc surface is cleaned.

•When replacing the DVD-RAM disc in cartridge, insert it until a click is heard.

Be careful not to allow condensation.

To store disc cartridge or caddy, insert in plastic

case provided.

Do not place the disc cartridge or caddy in the fol- lowing places:

Where exposed to direct sunlight for a long time.

Where the humidity is high, or in dusty place.

Where exposed to heat from heater, etc.

Where there may be condensation.

About Stored Data

If you handle or use the disc incorrectly, the re- corded data may be lost. Hitachi cannot be respon- sible for damages from loss of recorded data.

Removing and Replacing Disc from/in Cartridge or Caddy

The DVD-RAM disc used with this DVD video camera/recorder can be removed from the cartridge or caddy and used with DVD-RAM drives, DVD players and DVD recorders that are compatible with 8 cm DVD-RAM discs. The finalized DVD-R disc can also be removed from the cartridge or caddy and used with DVD players and DVD recorders that are compatible for 8 cm DVD-R discs. Refer to the disc in- struction sheet for details on how to remove disc from cartridge or caddy.

Perform the following to remove the disc:

With disc packed in cartridge

Removing the disc

1 Release the lock pins of cartridge. The two lock pins are at the bottom left corners of sides A and B.

English

Lock pins

Use a fine tipped pen to slide the lock pin in the direction of arrow 1, and then turn it in the di- rection of arrow 2 to release it.

2 While pushing the release levers from both sides inward, hold the center of disc tray and pull it out to the front.

24

Page 24
Image 24
Hitachi DZMV270A instruction manual About Stored Data, Removing and Replacing Disc from/in Cartridge or Caddy