English
ACCESSORY
WARNING: Accessory other than these shown below can lead to malfunction and resulting injuries.
STANDARD ACCESSORY
Dipstick | 1 |
APPLICATIONS
Air source of the pneumatic nailer and stapler.
WARNING: Never use compressor for applications other than compressor for pneumatic nailer and
stapler.
PRIOR TO OPERATION
1.Power source
Ensure that the power source to be utilized conforms to the power source requirements specified on the product nameplate.
2.Power switch
Ensure that the knob of the pressure switch is in the “OFF” position (Fig. 2). If the plug is connected to a receptacle while the knob is in the “ON” position, the compressor will start operating immediately and can cause serious injury.
ON |
OFF |
Knob of the pressure switch
Fig.2
3.Extension cord
When the work area is far away from the power source, use an extension cord of sufficient thickness and rated capacity (refer page 6). The extension cord should be kept as short as practicable.
WARNING: Damaged cord must be replaced or repaired.
4.Confirm the power receptacle
If the power receptacle only loosely accepts the plug, the receptacle must be repaired. Contact the nearest electric store for repair service.
If such a faulty receptacle is used, may cause overheating, resulting in a serious hazard.
5.Dipstick insertion and oil level check
Use a screwdriver or similar tool to remove the plastic cap on the lower part of the cylinder (Fig.3).
Cylinder
Plastic cap 
Fig.3
Insert the accessory dipstick all the way to the bottom. Remove the dipstick and make sure the oil level is within the range of the dipstick notches (Fig.4).
Air vent 
Dipstick
Max
Min
Fig.4
WARNING: Drain tank to release air pressure before removing the dipstick.
WARNING: Make sure air vent in dipstick is free from debris. If air vent is blocked pressure can
build in crankcase causing damage to compressor and possible personal injury.
When the oil volume is insufficient, refer to the section “Oil
6.Right running position
Position the compressor on a flat surface or one with an inclination of 10° at the most, in a well ventilated area away from atmospheric agents and not in explosive areas (Fig.5).
CAUTION : In order to avoid damaging the compres- sor, do not allow the unit to be tilted more
than 10° when operating.
NOTE: When operating or storing the copmressor, set 4 rubber bumpers downward on the floor (Refer to Fig.1)
10°max10°max
Fig.5
7.Temperature
Operating temperatures are between 32°F and 104°F (0°C and 40°C).
CAUTION: Never operate in temperatures below 32°F (0°C) or above 104°F (40°C).
- 8 -
