Hitachi ED-AW110N user manual ・%HVxuhWrXvhRqo\WkhEdwwhulhvVshfl¿Hg, Dwwhu\&Ryhu

Turn the projector off, and unplug the power cord. Allow the SURMHFWRUWRFRROVXI¿FLHQWO\

Replacing the internal clock battery

Consumption of the battery makes the clock not to work correctly. When the clock is wrong or it has stopped, please replace the battery according to the following procedures.

1.

2. After making sure that the projector has cooled adequately, slowly turn over the projector, so that the bottom is facing.

3. Turn the battery cover fully in the direction indicated “OPEN” using a coin or the like, and pick the cover up to

remove it.

4. 3U\XSWKHEDWWHU\XVLQJDÀDWKHDGVFUHZGULYHURUWKHOLNHWRWDNHLWRXW:KLOHSU\LQJLWXSSXWD¿QJHUOLJKWO\RQWKH battery since it may pop out of the holder.

5. Replace the battery with a newHITACHI MAXELL, Part No.CR2032 or CR2032H.

Slide the battery in under the plastic claw, and push it into the holder until it clicks.

6. Replace the battery cover in place, then turn it in the direction indicated “CLOSE´XVLQJVXFKDVFRLQVWR¿[

%DWWHU\&RYHU

90°

OPEN

CLOSE

OPEN CLOSE

ENGLISH

OPEN	CLOSE
OPEN	CLOSE

90°

WARNING ŹAlways handle the batteries with care and use them only as GLUHFWHG%DWWHU\PD\H[SORGHLIPLVWUHDWHG'RQRWUHFKDUJHGLVDVVHPEOHRU GLVSRVHRILQ¿UH

And also improper use may result in cracking or leakage, which could result in ¿UHLQMXU\DQGRUSROOXWLRQRIWKHVXUURXQGLQJHQYLURQPHQW

・%HVXUHWRXVHRQO\WKHEDWWHULHVVSHFL¿HG

・Make sure the plus and minus terminals are correctly aligned when loading a battery. ・.HHSDEDWWHU\DZD\IURPFKLOGUHQDQGSHWV,IVZDOORZHGFRQVXOWDSK\VLFLDQ

immediately for emergency treatment. ・Do not short circuit or solder a battery.

・'RQRWDOORZDEDWWHU\LQD¿UHRUZDWHU.HHSEDWWHULHVLQDGDUNFRRODQGGU\SODFH ・If you observe battery leakage, wipe out the leakage and then replace a battery. If the

leakage adheres to your body or clothes, rinse well with water immediately.

・2EH\WKHORFDOODZVRQGLVSRVLQJDEDWWHU\

21