English
ASSEMBLY AND OPERATION
APPLICATIONS
◯Use as a drill
Drilling of soft steel, wood, plastic and aluminum materials.
◯Use as a screwdriver
Tightening and loosening of machine screws, wood screws and tapping screws.
REMOVAL AND INSTALLATION METHOD OF BATTERY
Handle
Latch
Insert
Push
Pull out
Battery
Fig. 3
◯How to install the battery.
Align the battery with the groove in tool handle and slip it into place.
Always insert it all the way until it locks in place with a little click, If not, it may acciden- tally fall out of the tool, causing injury to you or someone around you. (Fig. 3)
◯How to remove the battery.
Withdraw battery from the tool handle while pressing the latch on the front of the battery. (Fig. 3)
CHARGING METHOD
NOTE: Before plugging into the receptacle, make sure the following points.
◯The power source voltage is stated on the nameplate.
◯The cord is not damaged.
WARNING: Do not charge at voltage higher than indicated on the nameplate.
If charged at voltage higher than indicated on the nameplate, the charger will burn up.
Battery
Pilot Lamp
1.Insert the battery to the battery charger.
Insert the battery into the battery charger as shown in Fig. 4. Make sure it contacts the bottom of the battery charger.
2.Insert the plug of battery charger into the receptacle.
| WARNING: Do not use the electrical |
| cord if damaged. Have it |
Fig. 4 | repaired immediately. |
|
12
