Hitachi P50T501A, P42T501 First time use, Front Panel Controls, Indicating Lamp, Operating

Front Panel Controls

￿POWER light indicator

To turn the TV ON, press the main power switch located on the lower right side of the TV. A red stand-by indicator lamp located on the lower right corner of the front bezel will illuminate. The Plasma TV is now ready for remote ON/OFF operation.

￿Indicating Lamp ￿ R/C sensor

First time use

Indicating Lamp Power Status		Operating
Off	OFF.	When the main power switch is set to Off.
Lights	OFF.	When the main power switch on the TV is ON.
Red	(Stand-by)
Lights	On	TV MAIN POWER is ON ; picture is shown.
Blue
Lights	Off	TV MAIN POWER is ON with no signal input
Orange	(Power Saving)	except antenna (no sync. signal).
Blinking	On	When TV receives the IR signal from R/C.
Blue

￿REMOTE CONTROL sensor

Point your remote at this area when selecting channels, adjusting volume, etc.

￿INPUT-FRONT JACKS

INPUT-FRONT provide composite Video jacks for connecting equipment with this capability, such as a DVD player or Camcorders.

NOTES: 1. Your HITACHI Plasma TV will appear to be turned OFF (lights orange) if there is no video input when INPUT : 1, 2, 3, Front or HDMI : 1, 2, Front is selected. Check the Power Light to

make sure the TV is turned off or in Stand-by mode (lights red) when not in use.

2.Remote Control can not turn ON/OFF the “MAIN POWER” of the TV.

13