Hitachi P55T501 Remote Control for DVD Functions, Dvd, Precoded DVD Buttons

The Remote Control for DVD Functions

The Remote Control

OPERATING THE PRECODED FUNCTION FOR YOUR DVD PLAYER.

This remote is designed to operate different types of DVD players. You must first program the remote to match the remote system of your DVD player (refer to

pages 37-38 for pre-codes).

1.Turn ON your DVD player.

2.To switch to DVD pre-coded mode, use the SOURCE SELECT button on the remote control to position the LED light to the corresponding selection

DVD.

3.Hold down the SOURCE SELECT button on the remote and enter the four digit preset code that matches your DVD player, as shown on pages 37-38. Release the SOURCE SELECT button. The indicator light will flash 3 times if the code was accepted.

4.Aim the remote at the DVD player and press the POWER button. The remote will turn off your DVD player when the correct four digit preset code is entered. When this occurs, the remote control is programmed for your DVD player. If the DVD player does not turn off, try a different four digit preset code.

5.The remote will now control your DVD player.

NOTE: 1. If your DVD player cannot be operated after performing the above procedures, your DVD player code has not been precoded into the remote.

2.In the unlikely event that your DVD player cannot be operated after performing the above procedures, please consult your DVD player operating guide.

3.The remote control will remember the codes you have programmed until the batteries are removed from the remote control. After replacing the batteries repeat the entire programming procedure as stated above.

￿PRECODED DVD Buttons

These buttons transmit the chosen precoded

DVD codes.

￿EXCLUSIVE TV Buttons

These buttons are for operating the TV.

￿

	￿
￿
	￿
￿	￿

￿

￿

￿

￿

MY DVD PLAYER CODE IS:

NOTE: Refer to instruction manual of the DVD Player for operation of the buttons exclusively for the DVD Player.

34