NAMES AND FUNCTIONS OF REMOTE CONTROL UNIT

REMOTE CONTROLLER

This controls the operation of the indoor unit. Signal range to reach indoor unit is about 7 meters. If inverter lamp is used, the range of control may be shorter.

This unit can be fi xed on a wall using the fi xture provided. Before fixing it, make sure the indoor unit can be controlled from the remote controller.

●Transmission sign

The transmission sign blinks when a signal is sent.

● Display

This indicates the room temperature selected, timer status, function and intensity of circulation selected.

● CIRCULATION button

Use this button to set air circulation in the room or start operation.

● DEHUMIDIFYING button

Use this button to reduce humidity in the room or start operation.

● COOLING button

Use this button to set cooling mode in the room or start operation. ● RESET button

● STOP button

Press this button to stop operation only.

● SLEEP button

Use this button to set the sleep timer.

●FAN SPEED selector

This determines the fan speed. Each time you press this button,

the intensity of circulation will change from (AUTO) to (HI) to (MED) to (LOW)

●AUTO SWING button

Controls the angle of the horizontal air defl ector.

●TEMPERATURE button

 

Use this button to raise or lower the temperature setting. (Keep

 

pressed, and the value will change more quickly.)

●

OFF-TIMER button Select the turn OFF time.

●

ON-TIMER button Select the turn ON time.

Precautions for Use

● Do not put the remote controller in the following places. ● In direct sunlight.

● In the vicinity of a heater.

● Handle the remote controller carefully. Do not drop it on the

fl oor, and protect it from water.

●Once the outdoor unit stops, it will not restart for about 3 minutes (unless you turn the power switch off and on or unplug the power cord and plug it in again).

This is to protect the device and does not indicate a failure.

– 6 –