|
| |
Perking noise | Noise of the ventilation fan sucking in air present in the drain hose and blowing out | |
dehumidifying water that had accumulated in the condensed water collector. For | ||
| details, consult your sales agent. | |
|
| |
Changing operation noise | Operation noise changes due to power variations according to room temperature | |
changes. | ||
| ||
|
| |
Mist emission | Mist is generated as the air within the room is suddenly cooled by conditioned air. | |
|
| |
Steam emitted from the outdoor unit | Water generated during defrosting operation evaporates and steam is emitted. | |
|
| |
Odors | Caused as the smells and particles of smoke, food, cosmetics, etc. present in room | |
air become attached the unit and blown off into the room again. | ||
| ||
|
| |
The outdoor unit continues to operate | Defrosting is underway (as the heating operation is stopped, the microcomputer | |
checks frost accumulated in the indoor unit and instructs the unit to perform automatic | ||
even if operation is stopped. | ||
defrosting if necessary). | ||
| ||
|
| |
| Shows preheating or defrosting operation is underway. | |
The OPERATION lamp is blinking. | As the protective circuit or preheat sensor operates when unit operation is stopped | |
during preheating and then restarted, or when operation mode is switched from | ||
| ||
| cooling to heating, the lamp continues to blink. | |
|
| |
Does not reach the temperature | Actual room temperature may deviate slightly from the remote controller’s | |
setting. | temperature setting depending on the number of people in the room, indoor or | |
| outdoor conditions. |
•If the unit still fails to operate normally after performing the above inspections, turn the circuit breaker off and contact your sales agent im- mediately.
Notes
Contact your sales agent immediately if the fol- lowing phenomena should occur:
• The circuit breaker switches off or the fuse blows frequently.
• The switch operation is not stable.
• Foreign matter or water accidentally enters the unit interior.
• The power cord gets excessively hot or its insulation is torn or stripped.
• TIMER lamp on the indoor unit display blinks.
(As the nature of the failure can be identified by the blinking cycle, ) check the blinking cycle before turning off the circuit breaker.
• In quiet operation or stopping the running, the following phenomena may occasionally occur, but they are not abnormal for the operation.
(1)Slight flowing noise of refrigerant in the refrigerating cycle.
(2)Slight rubbing noise from the fan casing which is cooled and then gradually warmed as operation stops.
• The odor will possibly be emitted from the room air conditioner because the various odor, emitted by smoke, foodstuffs, cosmetics and so on, sticks to it. So please clean the air filter and the evaporator regularly to reduce the odor.
•Please contact your sales agent immediately if the air conditioner still fails to operate normally after the above inspections. Inform your agent of the model of your unit, production number, date of installation. Please also inform him regarding the fault.
Please note:
On switching on the equipment, particularly when the room light is dimmed, a slight brightness fluctuation may occur. This is of no consequence.
The conditions of the local Power Supply Companies are to be observed.
– 20 –
