Caution
When the switch is turned "ON," this cannot be charged.
When the capacity of the battery is sufficient, the charging completion lamp may be turned off early. Charging by using an LED light dryer (Included in the
Connect the power adaptor to the LED light dryer and an outlet, and insert the main body socket into the charging connector of the LED light dryer. (Fig.3)
Caution
If the dry switch is pressed by mistake, the dry switch will flash. It will go out if the dry switch is pressed again.
When the battery is completely discharged, the charging completion lamp may not light.
If charging is continued as it is, the battery will start to be charged after the charging completion lamp has lit.
Recommended
Wipe off water droplets if adhered to the main body socket and the charging connector of the LED light dryer.
Please use another outlet if noise is generated from the TV, etc., during charging or operation. 2. After completion of charging, disconnect the power adaptor. (Fig.4)
Disconnect holding the plug portion.
During charging, the power adaptor and the main body may slightly heat up, this is not abnormal. After charging by using an LED light dryer (Included in the
After completion of charging, remove the main body from the charging connector while holding the LED light dryer, and disconnect the power adaptor from the outlet and LED light dryer. (Fig.5)
Used as a stand
The LED light dryer can be used as a stand by placing the main body since its socket portion fits in the center hole of the LED light dryer. Remove holding the plug portion.
The standard charging time is 1.5 hours.
With one charge, it can be used for about 15 days. (For use at three minutes per day.)
(The number of operating times may decrease depending on the operating conditions, such as beard thickness, pressing force to skin, method of maintenance, and low ambient temperature.)
Time to charge
If the remaining battery level indicator lamp flashes when the switch is turned "ON," this indicates that charging is required. Charge in good time. (Fig.6)
Remaining battery level indicator lamp (Does not light while charging.)
Guidelines for remaining battery level indicator lamps "HIGH," "MID" and "EMP" lamps light: 80% or more "MID" and "EMP" lamps light: 50% or more
"EMP" lamp light: Less than 50%
"EMP" lamp flashes: Charging is required
NOTICE
When the remaining battery level indicator lamp "EMP" flashes, the motor may stop automatically to prevent excessive discharge.
This product uses a
In order to deliver full performance, observe the following:
(1)Do not overcharge. The battery life will become short.
Charge after the remaining battery level indicator lamp “EMP” flashes.
(2)Charge on condition that the ambient temperature is 10°C or more and under 35°C. Due to the nature of the battery, it is recommended to charge in the range of 10 – 30°C. At lower or higher temperatures, the battery performance may deteriorate.
(3)Store in a dry, cool place.
Avoid storing in a hot place where the temperature is 40°C or more or in a cold place where it is 0°C or less.
