Never use any other power adaptor and LED light dryer than the ones included. Also, do not charge any other product with the included power adaptor. (Cause of fires by short circuits or abnormal heating)
Do not remove the main body from the LED light dryer during drying.
(Cause of burns by the light emitting lens or foil that becomes hot during drying)
Prohibited
Do not apply the trimming blade directly to ears and nose. (Cause of injury to ears and nose)
| Disconnect the power plug from the outlet when it is not used. |
| (Cause of injury, burns, or electric shocks and fires from electric leakage due to |
Unplug | insulation degradation) |
Safety precautions
1.Never use cream or gel shaving agents.
Cause of clogging and damage to the blade.
2.Never soak the blade in water.
Cause of damage to the shaver.
3.Never dry it using a dryer or a fan heater, etc.
Cause of deformation or damage to the shaver.
4.Do not charge at each time of use.
Cause of impairment of the battery performance
5.Do not dry any other body than this shaver with the LED light dryer.
Cause of failures
6.Do not place the LED light dryer in a tilted or unstable position, and do not move it during use.
Cause of failure of the equipment
7.Never allow to dry or leave it in a place exposed to direct sunlight and high temperatures.
Cause of damage to the shaver due to deformation and deterioration of the waterproof rubber.
8.Never wipe the shaver or the power adaptor with alcohol, benzene, and thinner, etc.
Cause of deformation and discoloration.
If the blade surfaces are applied to the skin too strongly as the battery level is low or maintenance is inadequate, an automatic stop may be made by the protection circuit functioning under an increased load. The shaver can be used by connecting the power adaptor and turning "ON" the switch again.
Charge as it is or carry out a sufficient level of maintenance.
(If the shaver does not move even when the switch is turned “ON,” connect the power adaptor to the main body, insert the power plug into an outlet, and then turn “ON” the switch again.)
Name and function of each portion (Fig.1)
Cap：Protects the blade. | Switch |
Head holder | If this switch is pressed, the shaver is |
| turned "ON" and if this is pressed again, |
Foil, cutter, center trimmer, | the shaver is turned "OFF". |
and cleaning washer are assembled. | Selector button |
Foil | Selects between auto mode, |
Cutter (Drum razor blade) | power mode, and normal mode. |
(incorporated in the cutter) | Battery (Built in) |
The cutter cannot be disconnected | Lithium ion battery 1 pc. |
from the | Main body socket |
Cleaning washer | |
Changes the flow to wash the cutter and | knob |
foil for maintenance. | By sliding this button sideways, the |
| |
| Head holder removal button |
| Never press this button during operation. |
