Installation |
安裝 |
Attention 注意
Please turn on the water tap to check to connecting condition of the water supply hose before washing.
開始洗衣前，請先打開水龍頭，檢查供水管的連接狀況。
To prevent damages caused by water leakage due to loosen screw.
如果螺釘鬆脫，會因漏水而招致不必要的損失。
How to install and remove the water supply hose
供水管的安裝方法和拆卸方法
Water tap
水龍頭
Do not allow water tap, one touch joint and rubber ring to touch the unit when installing them.
安裝水龍頭、便捷連接器以及滑環時，注意別讓它們碰到 洗衣機機體。
Main unit
機 體
Turn the union nut in the direction as shown by the arrow and firmly. Connect it to the water supply opening.
沿箭咀方向旋轉連接螺母，使其與供水口緊緊 相連。
■Installing
安裝方法
1Push down the rubber ring and insert the tap into the one touch joint.
將滑環下壓，然後插入便捷連 接器內。
Release the rubber ring and
2push up the water supply hose until it clicks.
放開滑環，向上推壓供水管， 直至發出“叭”的鎖緊聲為 止。
Pull the water supply hose to check that it does not come off easily.
拉一拉供水管，確認供水管 不會脫落。
■Removing
拆卸方法
One touch joint 
便捷連接器
Latch
搭扣
Rubber ring 
滑環
Water supply hose
供水管
Turn off
關
Latch
搭扣
Rubber ring
滑環
Attention 注意
Firmly tighten the union nut when con-
necting the water supply hose to the main unit.
請務必旋緊供水管與機體的連接螺母。
Failure to do so may result in water leakage.
螺母鬆脫的話，可能會漏水。
Loosely tightened union nut will cause water |
leakage. |
Turn off the water tap.
1關閉水龍頭。
Press the "START" button and let the unit run for
2aboutten seconds.
按下 動按鈕，運轉 10 秒鐘。
This is to prevent water splash when removing the tap.
為了防止拆卸時水花四濺。
3Remove the latch and the water supply hose while pushing down the rubber ring.
鬆開搭扣，拉下滑環，同時將供水管拔下。
連接螺母如不擰緊，可能產生漏水現象。 |
When removing the hose, unscrew the union |
nut first. |
拆卸時，擰下連接螺母，即可拆除。 |
Please note that water supply hose and one |
touch joint should be used. |
請使用隨機配套的供水管和便捷連接器。 |
The appliance is to be connected to the water |
mains using new |
sets should not be reused. |
應使用附帶的新的連接水管進行連接，舊的連 |
接水管不得再次使用。 |
12
