![](/images/new-backgrounds/1204933/20493349x1.webp)
BASIC OPERATION (continued)
Input Switching to HDMI and RGB
By pressing the Input Select button , you can switch the input to display the image outputting from the external equipment connected to each terminal (HDMI and RGB (/Composite)).
<From Remote Control>
Press the
button on the remote control.
Each time this button is pressed, the screen displays the corresponding mode in the following sequence.
HDMI
RGB (/Composite)
Press the
or
button to directly select the input mode.
<From Control panel>
The Input modes can also be switched using the Input Select button on the control panel.
Each time this button is pressed, the screen displays the corresponding mode in the following sequence.
HDMI
RGB (/Composite)
Menu button
Input Select button
RGB Input
Select button
HDMI Input
Select button
Input Select
ENGLISH
NOTE Switching between RGB and Composite Mode
When pressing button, you will see the image from either RGB or Composite mode. You can set up the mode in advance if necessary.
1.Press MENU button in RGB or Composite mode.
2.Select “Setup” menu.
3.Select “RGB input”.
Select “Composite” to display the image from a video source via the optional
cable.
Select “RGB” to display the image from PC. See 38 and 39 for details of “RGB input” menu.
Input Signal Screen Display
The input signal status can be displayed on the screen by pressing the | button on the remote control. |
The display will go out in approximately 6 seconds. |
|
HDMI mode
RGB mode
HDMI DVI
720p
RGB
H : 48.4kHz
V : 60.0 Hz
Input mode
*
Signal mode
*
Input mode Input horizontal frequency Input vertical frequency
INFO button
Composite mode
Composite
24